battat BT1820 Pop Up Tent Owner’s Manual
- September 28, 2024
- BATTAT
Table of Contents
batted BT1820 Pop-Up Tent
PIECES
FUNCTIONS
Requires 2 x AAA (1.5V). Batteries are not included. Non-rechargeable
batteries are not to be recharged. Rechargeable batteries are to be removed
from the toy before being charged. Rechargeable batteries are only to be
charged under adult
supervision. Different types of batteries or new and used batteries are not to
be mixed. Only batteries of the same or equivalent type as recommended are to
be used. Batteries are to be inserted with the correct polarity. Exhausted
batteries are to be removed from the toy. The supply terminals are not to be
short-circuited.
ATTENTION: When the module’s functions lose performance, follow
instructions carefully to install new batteries.
REPLACING BATTERIES
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, under Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used by the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment on, and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING : KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.
This tent meets the flammability requirements of CPAI-84. The fabric may burn
if left in continuous contact with any flame source. The application of any
foreign substance to the tent fabric may render the flame-resistant properties
ineffective.
2024 MAISON BATTAT INC. BT1820
Manufactured for Maison Battat Inc. 8440 Darnley Road, Montreal, P.Q. H4T 1M4
Designed by Maison Battat Inc. Battat® is a registered trademark of Maison
Battat Inc. Made in China. All Battat® products meet all US safety standards.
Colors may vary. Please retain this information for future reference. Please
remove all packaging materials before giving them to children.
HOW TO FOLD AND STORE THE TENT
HOW TO CORRECT THE TENT’S SHAPE
If the tent’s wire frame is bent, lift the top of the tent, bring both sides together, and then release to correct the shape. Repeat these steps if needed.
USER GUIDE
- The tent is not suitable for wet or rainy environments. If the tent gets wet, leave it open in an airy space to dry.
- To maintain quality, do not leave the tent in the sun for prolonged periods. Surface clean only.
- Young children require adult supervision when playing in the tent.
- ATTENTION: For pretend play use only. Clean the toy thoroughly before use.