Keyhole Hovering Panel Installation Guide
- September 27, 2024
- Keyhole
Table of Contents
Keyhole Hovering Panel
Instructions for installing the Keyhole hovering panel into a compatible piano shell.
Tools Needed
- Required tools ¼” hex head driver
- Recommended tools (nut driver above not necessary with these tools) drill driver, ¼” extension rod, ¼” hex bit
Instructions
- Note on 50-inch and larger models: you may need to remove the upright supports to allow the panel to fit/slide into the opening on the front of the piano.
- Prepare the panel by attaching the hardware as shown.
- The piano is carefully positioned upside down as shown [and with the sides open if TurnKey], and the panel into position.
- The insert is the same size as the rim opening, so line up the panel to match.
- Use [the supplied] ⅜” long hex head screws to anchor each bracket to the rim.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>