LUXRITE LR23738-40 2 Inch Gimbal LED Recessed Lighting Instructions

3”, 4” & 6” RECESSED MINI FLAT PANEL
STEP BAFFLED TRIM – 3 CCT SELECTABLE
LR23738, LR23739, LR23740 Instructions

WARNING
FOR SAFETY, READ AND UNDERSTAND INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION. ELECTRICITY SHOULD BE TURNED OFF AT THE FUSE OR THE CIRCUIT BREAKER BOX BEFORE INSTALLING THE FIXTURE. ALL ELECTRICAL CONNECTIONS MUST BE IN ACCORDANCE WITH ELECTRICAL AND LOCAL ELECTRICAL CODES.
CAUTION DISCONNECT POWER BEFORE CONNECTING TRIM TO HOUSING, FAIL TO DO SO MAY PERMANENTLY DAMAGE THE LED.

TOOLS REQUIRED

• SAW
• MEASURING TAPE
• ELECTRICAL WIRING (USE AND GAUGE SUITABLE FOR
  APPLICATION TO CONNECT THE FIXTURES.)

INSTRUCTIONS

1. RISK OF ELECTRIC SHOCK – TURN OFF POWER BEFORE INSTALLATION OR REMOVAL

2. Locate a suitable position to place the super-thin LED fixture and open a hole in accordance with the cut-hole dimensions (refer to Hole Cut Table for appropriate size).

3.  Run the electrical wire from the switch (power supply), through the mounting hole.

4. Open the hardwire box swing cover and remove the appropriate knockouts

5. Insert the electrical supply cable through the knockout.

6. Wire box using supplied quick-connect push-in terminals.
   – Connect the green ground wire of the cable to the green wire on the box.
   – Connect the white wire of the cable to the white wire on the box.
   – Connect the black wire of the cable to the black wire on the box. (FIG. 1)

7. Place all wiring and connections back into the box and close the cover. Remodel applications: Insert the junction box into the ceiling. (FIG. 2)

8. Push spring-loaded clips on the fixture upwards and insert the base into the mounting hole. Release the clips and fixture will be pulled flush into the ceiling. (FIG. 3)

9. Once assembly is complete, turn on the power to confirm fixture is working properly.

WARNING
FOR WET LOCATION INSTALLTION, AFTER THE FIXTURE IS INSTALLED ON THE CEILING, PUT SILICONE GLUE TO SEAL THE GAP BETWEEN THE FIXTURE AND THE CEILING.

OPERATING TEMPERATURE:

• –5ºF – 105ºF
• Suitable for damp location
• Airtight
• Type IC rated for direct contact with insulation

732-882-1500
luxrite.com

Documents / Resources

| LUXRITE LR23738-40 2 Inch Gimbal LED Recessed Lighting [pdf] Instructions
LR23738-40, 2 Inch Gimbal LED Recessed Lighting, LR23738-40 2 Inch Gimbal LED Recessed Lighting, Gimbal LED Recessed Lighting, LED Recessed Lighting, Recessed Lighting, Lighting
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>