LUXRITE LR24920 4-Inch 5 CCT Trimless Recessed Downlight Installation Guide
- June 4, 2024
- LUXRITE
Table of Contents
INSTALLATION GUIDE
4” 5 CCT TRIMLESS RECESSED DOWNLIGHT
LR24920
IMPORTANT: READ ALL INSTRUCTIONS BEFORE INSTALLING FIXTURES. KEEP IT FOR
FUTURE REFERENCE.
SAFETY: FOR YOUR SAFETY, THIS FIXTURE MUST BE WIRED IN ACCORDANCE WITH
LOCAL ELECTRICAL CODES AND ORDINANCES. ALL WORK SHOULD BE DONE BY A QUALIFIED
ELECTRICIAN.
WARNING: MAKE SURE POWER IS OFF FROM THE ELECTRICAL PANEL BEFORE STARTING
INSTALLATION OR ATTEMPTING ANY MAINTENANCE. INDOOR INSTALLATION ONLY. TOOLS
REQUIRED: SAW, MEASURING TAPE, ELECTRICAL WIRING (USE TAPE AND GAUGE SUITABLE
FOR APPLICATION TO CONNECT THE FIXTURES.
PRE-INSTALLATION:
- Turn the power OFF from the electrical panel before starting installation.
- Locate a suitable position to place the fixture and open it in accordance with the cut-hole dimensions (refer to Hole Cut Table for appropriate size)
- Run an electrical wire from the switch (power supply) through the mounting hole –use NMD90 Romex or BX cable.
- Align the inside edge of the Zer Clearance plaster frame to the drywall hole and screw it in place. (Fig. 1)
- Plaster over the plaster frame, e careful not to fill past raised rim. (Fig. 2)
DRIVER WIRING:
- Open the hardwire box swing cover and remove the appropriate knockout(s).
- Insert the electrical supply cable through the knockout and secure it with a cable connector (sold separately).
- Using wire nuts, connect the green ground wire of the cable to the green wire on the box. Connect the black wire of the cable to the black wire of the box. (Fig. 3)
- Place all wiring and connections back into the box and close the cover.
- Insert hardwire box through the mounting hole. (Fig. 4)
NEW CONSTRUCTION APPLICATIONS: Hardwire box shall be firmly secured to studs, joists, or similar fixed structural units.
REMODEL APPLICATIONS: Do not require the hardwire box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed.
FIXTURE INSTALLATION:
- Connect the fixture to the hardwire box by inserting and twisting the male/female connectors. (Fig. 3)
- Insert the fixture to the plaster frame, and secure the lamp by twisting the fixture appropriately to the plaster frame. (Fig. 4)
- Once assembly is complete, turn on the power to confirm fixture is working properly.
33 Randolph Ave. • Avenel NJ 07001 |
732-882-1500
www.allstarlighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>