LAUNCH OBD2 Scanner CRP123X Elite Scan Tool User Guide
- June 5, 2024
- Launch
Table of Contents
LAUNCH OBD2 Scanner CRP123X Elite Scan Tool
Display Tablet Overview
Charging & Turning On
There are two charging methods available:
Via Charging Cable: Plug one end of the included charging cable into the 5V charging port of the tool, and the other end to the external DC power.
Via Diagnostic Cable: Insert one end of the diagnostic cable into the
DB-15 connector of the tool, and the other end to the vehicle’s DLC. Once the
charging LED illuminates solid green, it indicates that the battery is fully
charged.
Press the [Power] button to power it on.
Getting Started
If it is the first time you have used this tool, you need to make some system settings and keep the diagnostic software synchronized with the latest version.
Follow the steps below to proceed.
Preparation
-
Turn the ignition off.
-
Locate vehicle’s DLC: It provides standard 16 pins and is generally located on driver’s side, about 12 inches away from the center of dashboard. See Figure DLC Location. If DLC is not equipped under dashboard, a label indicating its position will be given.
In case no DLC is found, please refer to Automobile Repair Manual. -
Plug one end of the diagnostic cable into the DB-15 connector of the tool, and tighten the captive screws. Connect the other end to the vehicle’s DLC.
*Note: The tool ONLY works with the 12V passenger cars equipped with standard OBD-II diagnostic socket. -
Turn the ignition key on.
Start Diagnostics
AutoDetect and manual diagnosis are supported. If the AutoDetect fails, you
can choose to input the VIN manually or exit the AutoDetect session to switch
to manual diagnosis mode.
*Note: If “Automatic detection on connect” in “Settings” is set as ON, this step can be ignored.
Input the VIN, and tap “OK”, the system will automatically identify the
vehicle model. If the vehicle VIN is successfully decoded, it will perform
auto-diagnosis until a diagnostic report is automatically output.
*Note: The most recognizable location for VIN is in the top left corner on the vehicle’s dashboard. Other locations include the driver’s door or post, and the firewall under the hood.
+86 755 8455 7891
overseas.service@cnlaunch.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>