TR Sports M365 Electric Scooter Foldable Motorised Scooters User Manual

TR Sports M365 Electric Scooter Foldable Motorised Scooters

Specification

brake

Brake| Light type| LED
Light|  |

User security

1. Avoid carrying people.
2. Wear security helmet before riding, do not one-handed riding.
3. Charging more than 6 hours for first riding.
4. Practice at open space, after knowing operation then riding.
5. Do not riding against traffic rules or unsafe situation.
6. Do not cut power during riding.
7. Do not riding on the uneven road (drop more than 3cm), it may lead to injury and damage of E-scooter.
8. Do not use this scooter when the temperature is below 5 degrees. For long term storage, make sure charging once per month.
9. During riding, the foot should keep on pedal.
10. When crossing uneven ground, please moving slow.
11. Do not riding on the ground which have much water, oil or freeze.
12. Adjust T tube to proper situation.
13. Do not soak in water above 5 cm or wash, it may cause motor, battery and circuit failure.

Warning and instruction

Do not operate the e-scooter before reading this user manual thoroughly. The manufacturer will not be responsible for any damage or accident due to improper use.

Routine warning

1. For your safety and others, please follow the traffic regulations.
2. Do not riding this E-scooter under bad visibility.
3. The E-scooter is not recommended for stunt drive, wheelie or jump,it will increase the possibility of injury and damage of E-scooter.
4. Avoid carrying people.

Need to know before riding

1. Make sure all foldable device are lock.
2. Please wear helmet and knee guard before riding.
3. Drive slowly on urban road, open space can drive faster.
4. Do not use battery to operate on holed road, keep away from water and fire.

Riding operation

Prepare riding

1. Choose an open ground.
2. Unfolding as described above.
3. Adjust handlebar height.

Riding (PAS)

1. Press power button for a second to turn on power.
2. In order to ensure the safety of users, the product adopt PAS start. First, put one foot on the pedal, another foot on the ground, then slide, at the same time to press the accelerator dip.
3. E-scooter slide forward, put the foot on the ground to pedal. Adjust speed via the angel of accelerator dip.

Brake
This E-scooter equipped with front and rear disc brake and EABS Electromagnetic brake. Pull back brake handle, then put foot on the ground.
Remember do not sudden brake or only use front brake, it may lead to serious consequence, like turn over and so on.
Note
Do not use this E-scooter in bad weather like freeze, snow and foggy.

LCD Display Instruction

Basic Parameter:
outputs: 30V-80V Input voltage: 30V-80V
Working power: 1W±10% Wattage: 1W±10%

Dashboard:

1. Battery
2. P = parking
3. D = Drive
4. Speed Mode: 1 or 2 or 3
5. Headlight
6. Speed
7. Mileage (the mileage KM will be showed within 10 seconds after turning power on, after 10 seconds, it show voltage when riding, 3 seconds after parking the single range will be showed at this position).

Wire Connection:
Throttle Positive: pink
Throttle Negative: Black
Horn Signal: Green
Speed Wire: Blue
Head lihgt Signal: White
Lock: Red in, Yellow out.

Battery & charging instruction

Battery

1. Do not operate motor under charging.
2. Battery shows on the display only for reference.
3. Charging one time every 30-60 days for long time storage.
4. Low battery voltage may influence mileage, long-term low power will reduce battery life, so, make sure there is enough electricity before riding.

Do not use battery under following condition

1. Broken.
2. Release abnormal smell and heat.
3. Any leakage happened.
4. Avoid contact with leakage from battery.
5. Keep battery away from baby and pet.

Charger and battery

1. This E-scooter is outer charger. First connect charger plug to E-scooter, charger port is on the upper right of pedal, then connect charger plug to power.
2. Charger indicate red—in charging Charger indicate green—finished charging
3. In order to protect controller, pull out plug in time when finished charging.
4. To keep battery in good condition, charging 9 hours per time per month.
5. Do not use any tools to open battery or insert into battery, it may cause injury, burning or fire accident.
6. Please use original standard charger to recharge battery.

Battery and charger
Each E-scooter equipped with a special lithium battery, other types of battery do not use this battery charger.

Lithium battery
It is good to charge battery anytime. For long term storage, make sure charging once per month. If can not charge, contact with distributor.

Charger
Charger have overcharge protection function, when the battery is fully charged, will stop charging automatically.

Charging instruction

1. Connect charging plug to E-scooter charging port.
2. Insert charger plug into socket (AC100-240V)
3. When charger light turn red, it means battery is under charging condition, when it turn green, means battery is fully charged. We suggest to charge 2 hours more when it turn green.

Quick repair
Our E-scooter is assembly by professionals, do not install and change any part of E-scooter, it will influence whole performance. In this way, manufacture can not provide any guaranteed service.

Repair and maintenance

Flat tire maintenance

1. Check if the charger is pull out and power cut off
2. Put E-scooter to a higher and stable table, hanging front and rear tyre.
3. Use spanner to remove screws then take down motor.
4. Pull out all wires connected to motor.
5. Remember the order of motor gasket
6. Use professional crowbar(not plastic material or too big) to apart tyre from motor, note to protect motor, hub, tyre and inner tyre.
7. Air inflation to 20-28PSI.
8. Rear wheel locking torque≥30N.m.

Maintenance

When the brake performance began to decline, adjust the adjuster on brake cable to certain sensitivity. If it doesn’t work or have noisy when need to brake, please contact distributor to change brake pads.
The lithium battery can be recharged for 400 times, if the mileage become short distance, please change lithium battery.

General troubleshooting

Checklist

When the product doesn’t work properly, check the following:

1. If the power has been open
2. Power adequacy
3. The brake pull up
4. Make sure socket and connector are clean and connect well If the above mentioned is ok then contact distributor.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>