DOMUS LINE SRL KINYUL Wireless Kinetic Switch Instructions
- September 21, 2024
- DOMUS LINE SRL
Table of Contents
DOMUS LINE SRL KINYUL Wireless Kinetic Switch
DESCRIPTION
The Wireless Kinetic Switch is a push-button self-powered switch with MEA (Micro Energy Acquisition) module inside to transform mechanical energy into electricity to drive RF chipset work.
It is able to power on/off after the pairing with E be long Wireless receiving controller.
OPERATION
The Wireless Kinetic Switch shall work with Wireless Receiving Controller.
Press and hold the function button of controller for 3 seconds and the
indicator light will start to flash. Then release the button to enter pairing
mode. Press the switch and the indicator light of controller will go out,
which means the paring is successful.
Difference
Shape of the base one is rectangle, one is octagon.
The installation method one is with magnetic, another without.
SPECIFICATIONS
| Item | Spec |
|---|---|
| Switch type | Push button |
| Power mode | Self-powered |
| Modulation mode | FSK |
| Work frequency | 433.3 MHz |
| Button | 2 gang |
| Work range | 80m Outdoor, 30m Indoor |
| Lifetime | >100,000 times |
| Dimensions | L33W16H65mm |
| Tray | L56W4H107mm |
| Work temperature | -20~ +55°C |
FCC Warning
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Portable device statements
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
IC warning
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>