CLEARMIRROR 10.21 Wall Mount Shower Shelves User Manual

Table of Contents

CLEARMIRROR-10-21-Wall-Mount-Shower-Shelves-product

Clean the Shower Wall: Wipe the shower wall clean and ensure it is dry.
Determine Mounting Location: Use a level and pencil to mark a straight line for the mounting location.
Clean the Wall Surface: Use the provided rubbing alcohol wipes to clean the area where the VHB tape will contact the wall. Allow it to dry for at least 1 minute.
Apply 3M Primer:
- Shake before opening.
- Break pen by squeezing on the black dot to allow primer to soak into the foam tip.
Apply Primer: Apply primer to the area where VHB tape will contact the wall and allow it to dry for 5 minutes.
Mount the Shelf:
- Peel off the protective layers from the VHB tape on the back of the shelf.
- Align the shelf with the pencil marks and use a level for orientation.
- Press firmly for 1 minute to ensure good adhesive contact with the wall.
Allow Drying Time:
- Avoid using the shower for 24 hours after installation.
- Allow 72 hours for the adhesive to fully dry before placing items on the shelf.

FAQ – Frequently Asked Questions:

What is the weight capacity of the ClearMirror Wall-Mount Shower Shelves?
The weight capacity of the shelves is up to 8 pounds. Please ensure not to exceed this limit for safety reasons.
Can I install the shelves without drilling?
Yes, these shelves are designed for easy installation without the need for drilling. Follow the provided instructions for a hassle-free setup.
How long should I wait before using the shower after mounting the shelves?
It is recommended to wait for 24 hours after installation before using the shower to allow the adhesive to set properly.

Stylish and the ideal companion to your fog-free Shower ClearMirror. Installation is easy with no drilling required.

Clean the shower wall and dry.
Determine general location for shelf. Use a level and a pencil to mark a straight line for the mounting location.
Use the provided rubbing alcohol wipes to clean the area where the VHB tape will contact the wall. Allow at least 1 minute to dry.
Apply 3M Primer:
- Shake before opening.
- Break pen by squeezing on the black dot. Primer will soak into the foam tip.
Apply primer to the area where VHB tape will contact the wall. Allow 5 minutes to dry.
Peel off the protective layers from the VHB tape (located on the back of the shelf).
Mount the shelf to the wall using your pencil mark guides. Use a small level placed on the top of the shelf to help with orientation.
Press firmly for 1 full minute to ensure the adhesive has a good contact with the shower wall. The harder and longer you press, the better the adhesive will work.
Do not use the shower for 24 hours.
Adhesive must fully dry before putting weight on the shelf. Allow for 72 hours to pass before putting items on the shelf.