Infinix NOTE 40 5G Smart Phone User Manual
- September 21, 2024
- Infinix
Table of Contents
Infinix NOTE 40 5G Smart Phone
Exploded diagram specification
| 1 | PANEL ELEMENT | 2 | FRONT SHELL_ASSEMBLY |
|---|---|---|---|
| 3 | USB_DUSTPROOF RUBBER | 4 | LCM_FPC_ADH |
| 5 | BATTERY_ADH | 6 | MAIN FPC |
| 7 | SIDEKEY_FPC FINISHED PIECE | 8 | REAL AUXILIARY CAMERA ASSEMBLY |
| 9 | POLYMER LITHIUM-ION BATTERY | 10 | ASSISTANT_PCB |
| 11 | SCREW M1.42.52.0L | 12 | MOTOR |
| 13 | NFC+Wireless charging | 14 | BOX SPK_FPC |
| 15 | BOX_SPK | 16 | RF COAXIAL LINE_SAME DIRECTION |
| 17 | SIDEKEY | 18 | MIDDLE FRAME_COOLING FIN |
| 19 | MIDDLE FRAME | 20 | LAMP EFFICACY FPC_BTB_BRACKET |
| 21 | SCREW M1.42.53.5L | 22 | BATTERY COVER |
| 23 | FLASHING LIGHT_CASING_ASSEMBLY | 24 | DECO_BRACKET_ASSEMBLY |
| 25 | ASSISTANT_CAMERA_RUBBER | 26 | IR_LED_CASING_ASSEMBLY |
| 27 | SIM CARD DRAWER | 28 | RF COAXIAL LINE |
| 29 | PCBA_BOT_COOLING FIN | 30 | ASSISTANT_CAMERA |
| --- | --- | --- | --- |
| 31 | CPS_CAMERA_MODULE | 32 | FLASHING LIGHT_FPC |
| 33 | MAIN CAMERA | 34 | LAMP EFFICACY_FPC |
| 35 | RECEIVER_SPK | 36 | MAIN_PCBA |
| 37 | PCBA_TOP_COPPER FOIL | 38 | FRONT CAMERA |
| 39 | LP_CASING_RUBBER | 40 | LP_CASING |
| 41 | FRONT_FLASHING LIGHT_CASING | 42 | FRONT SHELL_COOLING FIN_02 |
| 43 | FRONT SHELL_COOLING FIN_01 |
Know your phone
- Front camera
- Volume + button
- Volume button
- Power button
- NFC Wireless charging
SIM/SD card installation
- Power off your phone.
- Refer to the following picture for SIM/SD card installation.
Charging the phone
You can charge your phone with a charger or by connecting it to a computer
using a USB cable (comes with the phone).
Use only Infinix chargers and cables. Other chargers or cables may damage the
phone and invalidate its warranty.
FCC Caution
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
- Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.
Information to the user
Note : This device has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses and
may radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this device does cause harmful
interference to radio or television reception (able to be determined by
turning the device off and on), the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information
This mobile phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards developed by independent
scientific organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety margin designed
to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement
The SAR limit of USA (FCC) is 1.60 W/kg averaged over one gram of tissue.
Device types: X6852 (FCC ID: 2AIZN-X6852) has also been tested against this
SAR limit. The highest SAR value reported under this standard during product
certification for use at the ear is 1.16 W/kg and when properly worn on the
body is 1.04 W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 1.0 cm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights Reserved.
Operating System: AndroidTM
Android is a trademark of Google LLC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>