PHILIPS SWS200,SWS201 Wireless Switch Installation Guide
- September 18, 2024
- Philips
Table of Contents
PHILIPS SWS200,SWS201 Wireless Switch
Product Specifications
- Product Model: SWS200, SWS201 Wireless Switch
- Dimensions: 123.8 mm x 83.8 mm x 79.4 mm
- Weight: 0.072 kg
- Power Source: CR2032 Battery
- Compliance: Innovation, Science and Economic Development Canada’s licence-exempt RSS(s)
Product Usage Instructions
Installation Instructions
Follow these steps to install the wireless switch:
- Identify the junction box or drywall for installation.
- Mount the switch using the provided screws and secure it in place.
- Ensure proper alignment for optimal performance.
Commissioning and Decommissioning
To commission the switch:
- Use the Philips Field App to set up the switch.
- Follow on-screen instructions for pairing and configuration.
To decommission the switch:
-
* Press and hold the ON button for 5 seconds until the device flashes.- The switch will be reset and can be reconfigured as needed.
Safety Instructions
Ensure the following safety precautions:
-
* * Avoid contact with chemicals from batteries.- Properly dispose of used batteries to prevent injury.
WHAT IN THE BOX
DIMENSION
INFO
INSTALLATION INSTRUCTION
www.lighting.philips.com/main/products/interactready
FCC
FCC/IC compliance statement
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept anyinterference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
- This equipment must be installed and operated with minimum distance 200 mm between the radiator & your body
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
IC Radiation Exposure Statement
- This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
- This equipment must be installed and operated with a minimum distance of 200 mm between the radiator & your body
WARNING: Chemical Burn Hazard. Keep batteries away from children.
This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
The cells shall be disposed of properly, including keeping them away from children; and even used cells may cause injury.
Frequently Asked Questions
- Q: How do I change the battery in the wireless switch?
- A: To change the battery, follow these steps:
- Open the battery compartment on the back of the switch.
- Remove the old battery and insert a new CR2032 battery with the correct polarity.
- Close the battery compartment securely.
- Q: Can the wireless switch be used outdoors?
- A: It is recommended to use the wireless switch in indoor environments to maintain optimal performance and longevity.