ROKUHAN JNR Series O Shinkansen Light Instruction Manual
- September 14, 2024
- ROKUHAN
Table of Contents
ROKUHAN JNR Series O Shinkansen Light
Thank you for purchasing this Rokuhan product. This product is precise. Please read this instruction manual carefully before operating and operate properly.
Safety Caution
- Use only a Rokuhan controller to operate this product.
- Clean track (Metal rails) before operation.
- Remove dirt and dust on wheels.
- Do NOT operate continuously over a long period of time.
- Do NOT suddenly change train direction. Stop train first then change direction.
- In the case of derailment or short circuit, turn off the power of controller, unplug the controller, and then eliminate the cause of problem.
- Disassembling and modification could cause failure of this product.
- Storing this product in direct sunlight or fluorescent light for long time could cause change in color.
- Store and operate this product in dry dust free locations, away from sources of heat.
- To avoid shock or electrocution, do not operate this product in a wet location or operate with wet hands.
- This product includes sharp parts. Handle with care.
- Handle tools with care.
- This product is not recommended for use by children under 15 years old unless supervised by an adult.
- Please make sure to wrap the cars with a Poly bag to avoid any damage when you pack the cars into a blister package.
Contents of Product and Formation
Formation
Caution to handling train
How to set pantograph height
Applicable model 26-36, 26-235, 26-236, 16-18, 26-35, 22-18
- Pull up top part softly by stick until stopped. (See Figure 1)
- Push down the top part softly until touches. (See Figure 2)
Connect and disconnect cars
-
Connect cars
Place the cars on the straight track using Rerailer (Sold separately). Cramp each car by finger, shift the car (with Hook type coupler) forward, and connect both cars. (See Figure 3) -
Dis-connect cars
Cramp each car by finger and turn the car (with Hook type coupler) over, then both cars are disconnected. (See Figure 4)
How to apply Instant lettering
How to apply Instant lettering (For advanced modeler)
You can use the included instant lettering and Type 15 and Type 16 marks.
Remove any dirt or dust from the surface to be attached and place it on the
car body, as shown in Figure 5. After determining the position, rub gently to
ensure it does not shift, transfer, and attach.
Accessories
Accessories (Sold separately)
Room light Applicable model • All cars
You can install the room lights (sold separately) for this product in all
cars. For details, please refer to Figure 6 and check the interior light or
DCC decoder type room light (A059) compatible with each car. Install it
referring to the instruction manual that comes with each.
Troubleshooting
Check the following before ordering repair.
Trouble and repair
- The user is responsible for any trouble, accident, or injury caused by misuse, disassembling, or modification of this product. Rokuhan will not repair a product that has been opened, taken apart, or modified.
- Specification and appearance of our products are subject to change without prior notice.
- We sell assembled products only.
- Contact Rokuhan customer service if you have any questions about this product.
TOYTEC CORPORATION
- 1-27, NUMAWADA, TOCHIGI-CITY, 328-0042, JAPAN.
- TEL: 81-282-20-2365
- URL: http://www.rokuhan.com/.