ROKUHAN R095 Double Viaduct Track Set Instruction Manual

Viaduct Track Set R095 Double
Instruction Manual

Thank you for purchasing this Rokuhan product. This product is precision product. Please read this instruction manual carefully before operation and operate properly.

R095 Double Viaduct Track Set

Caution

• For best results, connect and disconnect the track on a flat surface. To avoiddamage to rail joiners and rail, DO NOT twist or use excessive force at large angles when assembling your track.

• Check your track is connected correctly before running your train. Each rail joint should be flush no humps.
  If a rail is not flush, the train could detail and could cause damage to your train or track.

• andle the cord with care to avoid breaking or short circuit.

• Remove dirt from the rail with a railcleaner before use. Dirty track is evident in jerky movement of your train and headlights that flicker. The power cannot reach the engine if track and wheels are dirty.

• DO NOT store in a high-temperature/humidity area or away from source of heat. Also be careful with chemicals such as thinner to avoid deformation.

• This product is not recommended for use by children under 15 years old unless superviced by an adult.

Parts list

1. Double viaduct straight track 110mm —— 7pcs
2. Double viaduct straight track 110mm…………… 1pc (With feeder cable)
3. Double viaduct curved track ……………….. 12pcs R195/220-30°
4. Pier …………………………….. 20pcs
5. Overhead mast (2 types)………………. each type 20pcs (Runner part 20pcs)
6. Pier Jabel………………………………. 1pc
7. Instruction manual………………………1pc

Guideline to assemble the layout

Separate the overhead mast from the runner, and install A and B in the positions as shown in the left figure.

Guideline to assemble tracks and parts

3-1 Guideline to assemble pier

The piers will come off easily if you use them as they are, so please attach the available “Pier label” before use.
Referring to Figure 2, fit the piers bumps into the iron bridge’s gray areas.
Fix by inserting the bump of the pier with the viaduct.

3-2 Guideline to assemble the overhead mast
Separate them carefully from the runner parts and insert them into the viaduct holes.
Refer to [Guideline to assemble the layout] for the mounting position.

Guideline to connect the controller

• Pattern A
  Both internal and external lines can be operated with their respective controllers.

• Train controller RC-02 x 2pcs or RC-03 x 2 pcs or RC-02 x Ipe and RC-03 x 1 pe.

• You can combine them as you like.

• Pattern B Internal and external lines can be operated at the same time.
  (Separate operation is not possible.)

• Train controller RC-02 x 1 pe or RC-03 x 1 pc

• A029 Y cable x 1 pc

Trouble and repair

• The user is responsible for any trouble, accident, or injury caused by misuse, disassembling, or modification to this product.
  Rokuhan will not repair a product which has been opened, taken apart, or modified.

• Specification and appearance of our products are subject to change without prior notice.

• Contact Rokuhan customer service if you have any questions.

7-27, NUMAWADA, TOCHIGECITY,
328-0042, JAPAN.
TEL : 81-282-20-2365
URL : http://www.rokuhan.com/

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>