MINIMEX 1000-63-64 Super Rich Espresso Machine Instruction Manual

MINIMEX 1000-63-64 Super Rich Espresso Machine

IMPORTANT SAFEGUARDS

Before using a machine always carefully read and comply with all these instructions. We cannot accept any responsibility for the consequences of improper use.

1. Check the voltage to be sure that the voltage indicated on the name plate agrees with your voltage.
2. This appliance has been incorporated with a grounded plug. Please ensure the wall outlet in your house is well-earthed.
3. Close supervision is necessary when the appliance is used by people. Place the machine out of the reach of children and persons with limited capabilities.
4. Do not place on or near a hot gas or electric burner or in a heated oven.
5. Unplug from the outlet when not in use and before cleaning. Allow to cool before putting or taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appli ance to the nearest authorized service facility for examination, repair or adjustment.
7. The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock, or injury to persons.
8. Be careful to ensure that the power cable does not become trapped and does not rub against sharp edges.
9. Do not let the cord hang over the edge of a table or counter, or touch hot surfaces.
10. Do not touch any hot parts. Use the handle of the funnel.
11. To protect against fire, electric shock, and injury to persons, do not immerse cords, plugs, or the body of the machine in water or other liquid.
12. It must be protected against freezing conditions.
13. Please fill up no more than 1.7L to the upper MAX mark, when pure water is in the water tank.
14. Once the fault, defect, or machine drop is caused by a suspicious defect, unplug the power plug immediately, and do not operate on the problem machine.
15. Do not use outdoors.
16. SAVE THESE INSTRUCTIONS

Accessories

1. Power Switch
2. Coffee Button
3. Steam Button
4. Hot water button
5. Drip piece
6. Drip tray
7. Steam nozzle
8. Steam / hot water knob
9. Steam indicator
10. Coffee indicator
11. Water tank
12. Water tank cover
13. Top cover / Cup warmer
14. Coffee Spoon
15. Filter
16. Filter holder

FOR THE FIRST USE

• Move the coffee maker from the package, and check the accessories according to the list.
• Clean all the detachable components
• Operation the appliance according to the sections “B” and “C” (no coffee powder in the filter). Repeat 2-3 times.

MAKE ESPRESSO COFFEE

• Open the lid, take out the water tank, and pour the appropriate water into the tank. Do not exceed the MAX capacity;
• Put back the water tank and close the lid;
• Connect the power plug, and press the power button, the machine will automatically pump water about 8s, and the coffee indicator and steam indicator always light on, then the coffee indicator is flashing and the machine start preheating, the coffee indicator will light on and the then preheating finished after 3min;
• Take out the filter holder, pour the appropriate coffee powder into the filter with a coffee spoon, and then press the coffee powder tightly;
• Lock the filter holder into the group head
• Put cup(s) under coffee outlet;
• Start brewing by pressing a coffee button;
• Remove the filter holder, knock it out clean it with hot water immediately, and lock it again for next use.

Note: Check frequently the water level in the tank. Refill if necessary. Do not touch the hot surfaces of the machine with your hands, especially the brewing outlet, or steam nozzle when using the machine.

FROTHING MILK/ MAKE CAPPUCCINO

• Prepare espresso first with a large enough cup according to part “B. MAKE ESPRESSO COFFE.
• Use whole, fresh cold milk out of the fridge (8-10ºC), and pour 1/3 milk into a cup.

Note: Use a stainless steel cup, and the cup diameter should not be less than 70 due to the volume of milk will increase after frothing.

• Press the steam button, and it starts preheating, and the steam indicator flashes, then wait for the lamp light on;
• Put a stainless steel cup under steam nozzle;
• Open the knob, release the steam, make the steam nozzle float on the surface of the milk, and adjust the height of the steel cup to froth milk;
• Remove the product when finished, turn off the knob, and Pour the frothed milk into the espresso prepared, now the cappuccino is ready.

Note: Purge steam to clean steam nozzle after use, warning hot surface

MAKE HOT WATER

• Put a stainless steel container under steam nozzle;
• Open the knob after the coffee indicator always lights on, then hot water is ejected from the steam nozzle;
• Close the knob when the desired amount is reached.

Note: Check frequently the water level in the tank. Refill if necessary. Do not touch the hot surfaces of the machine with your hands, especially the brewing outlet, or steam nozzle when using the machine.

HEATING LIQUID

• Use a stainless steel cup, and pour cold liquid into 1/2 cup;

Note : Cup diameter should not less than 70 ± 5mm.

• Press the steam button, it starts preheating, and steam indicator is flashing, then wait for lamp lights on;
• Put cup under steam nozzle;
• Turn on the knob, release steam, let the steam nozzle is inserted into the liquid;
• Turn off the knob when the desired temperature is reached.

Note : When steam is stopped, clean the steam nozzle immediately, and release the liquid in the pipe, to prevent the liquid scaling, because the surface temper ture of steam pipe is very high when in use, be careful not to be scalded.

INDICATOR TIPS

naturally fall or press the coffee button to boil water to cooling
Flashing| Flashing| NTC is an open circuit or short circuit| Please contact the authorized service facility for repair.
Flashing| Lights off| Making coffee for too long| Turn off the coffee button
Flashing| Lights off| Making hot water too long| Turn off the knob
Lights off| Flashing| Making coffee for too long| Turn off the knob

CLEAN AND MAINTENANCE

• The machine has to be switched off and cooled down.
• Clean housing with a damp cloth.

Note: Do not use abrasive sponges detergents or solvents. Do not immerse the machine in water.

• Clean the steam outlet, and confirm there is no blockage.
• Brush the outlet and the seal under the group head;
• Rinse with hot water to dissolve any coffee bean oil residue.
• Clean all the detachable attachments in the water and dry them thoroughly

CLEANING MINERAL DEPOSITS

• The machine builds up limescale deposits over time, and you need to descale the machine for 2-3 months;
• Pour water and descaler in the water tank up to MAX capacity (water and descaler ratio follows the instruction of the descaler. Please use “household descaler”, or you can use the citric acid replace descaler (water and citric acid rat io are 100:3).
• Lock the filter holder (no coffee powder) into the group head. According to part “B” MAKE ESPRESSO COFFEE.
• Press the coffee button, then make about 150ml coffee after coffee indicator lights on, turn off coffee button and turn on steam button, then open the knob after the steam indica tor lights on, release the steam about 2min, and turn off the knob, and then make descalers deposit in the machine at least 15min.
• Repeat the steps 4 for 3 times;
• Press the coffee button to brew coffee until there is no descaler left;
• Make coffee again(no coffee powder), repeat the steps 4 for 3 times (no need wait for 15 min), then brew until no water is left in the boiler;
• Repeat step 7 at least 3 times to make sure the piping is cleanly.

Product specification

TROUBLE SHOOTING

No water comes out

| The water tank is empty| Pour water into the water tank
The input voltage or frequency is inconsistent with the nameplate| Make sure the voltage and frequency are consistent with the nameplate
Machine malfunctions| please contact the authorized service

No steam is generated

| Steam nozzle clogged| Clean steam nozzle
The water tank is empty| Pour water into the water tank
Machine malfunctions| please contact the authorized service

Coffee runs out around the edge of the filter holder

| Too much coffee in the filter| clean the filter, then pour the appropriate coffee powder
There is coffee in the seal under the group head| Clean the seal under the group head

Coffee comes out too slow or no coffee comes out

| The coffee grind is too fine, and the clogged filter| With thicker coffee powder
Filter holes are blocked| Brush / clean the filter
The water tank is not inserted| Insert the water tank into place
There is water leakage on the bottom of the coffee machine| The drip tray is filled up| Please clean the drip tray
Machine malfunctions| please contact the authorized service

The machine is not working

| The power outlet is not plugged in well.| Plug the power cord correctly,
NTC is a short-circuit| please contact the authorized service
Machine malfunctions|

The steam cannot froth.

| The steam indicator is flashing| Wait for the steam indicator light on.
The container is too big or the shape does not fit| Use high and narrow cups or garland cup
used skimmed milk| Use whole milk

Warranty

The warranty for this Minimex Super Rich covers the defective parts and materials for 1 year after the date of purchase. This warranty is not valid for natural wares and tears and accidents that take place in the machine (such as a drop of the machine, or an electricity search). This warranty is void if the user does not use it according to the instructions described in this manual, or if the service is by third parties that are not our authorized person. Should you need any information, please contact tour MiniMex service center Tel: 02 817 8999

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>