Minimex MDC3 Coffee Maker Instruction Manual

**Minimex MDC3 Coffee Maker Instruction Manual

**

IMPORTANT SAFEGUARDS

When using electrical appliance. Basic safety precautions should always be followed including the following:

1. Read all instructions.
2. Make sure that your outlet voltage corresponds to the voltage stated on the rating label of the coffee maker.
3. To protect against fire, electric shock and injury to persons do not immerse cord, plug, or in water or other liquid.
4. Close supervision is necessary when any appliance is used by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. Return appliance to an authorized service facility for examination, repair or adjustment.
7. The use of accessory not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot surface.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Do not use appliance for other than intended use.
12. Do not clean carafe with cleansers, steel wool pads, or other abrasive material.
13. To disconnect, turn any control to “Off”, remove plug from wall outlet. Always hold the plug. But never pull the cord.
14. Scalding may occur if the cover is removed during the brewing cycles. Be careful not to get burned by the steam.
15. Some parts of appliance are hot when operated, so do not touch with hand. Use handles or knobs only.
16. Do not set a hot carafe on a hot or cold surface.
17. Do not let the coffee maker operate without water.
18. Do not use a cracked carafe or a carafe having a loose or weakened handle.
19. Please do not open the top cover and make sure the glass carafe is placed on the thermal insulation plate correctly during the brewing.
20. To reduce the risk of fire or electrical shock, do not remove the cover. No user serviceable parts inside. Repair should be done by authorized service personnel only.
21. The carafe is designed for use with this appliance. It must never be used on a range top.
22. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
23. Children should be supervised to ensure that they do not play with the appliance.
24. This appliance is intended to be used in household and similar applications such as:
    • staff kitchen areas in shops, offices and other working environments;
    • farm houses;
    • by clients in hotels, motels and other residential type environments;
    • bed and breakfast type environments.
25. Save these instructions.

KNOW YOUR COFFEE MAKER

1. Filter
2. Funnel
3. Carafe lid
4. Carafe handle
5. Carafe
6. Control panel
7. Warmer plate
8. Funnel Support
9. Tank handle
10. Tank

CONTROL PANEL

BEFORE FIRST USE

Check that all accessories are complete and the unit is not damaged. Fill water into water tank to the MAX level and brew water for several times without coffee powder, then discard the water. Clean and dry all detachable parts thoroughly according to the section “ CLEANING AND MAINTENANCE”

USING YOUR COFFEE MAKER

1. Open the top cover and fill the water tank with drinking water. The water level should not exceed MAX level as indicated on the water level gauge.

2. Place the funnel into the funnel support, make sure it is assembled correctly, otherwise the top cover cannot be closed. Place a filter in the funnel.

3. Add coffee powder into the filter. Usually a cup of coffee needs a level spoon of coffee powder (You can add coffee to the MAX level,about 45 grams of coffee), but you may adjust according to personal taste. Close the top cover completely.

4. Insert the glass carafe with lid closed onto the thermal insulation plate horizontally.

5. Plug the power cord into the outlet, the LCD display indicates “12:00” and it blinks.

6. Press to the “HOUR” setting, one hour can be increased. And the “HOUR” can be increased fast if hold and press the button for more than 2 seconds.

7. Press to the “MIN” setting, one minute can be increased. And the “MIN” can be increased fast if hold and press the button for more than 2 seconds.

8. Press to the “ON/OFF” setting, the ON/OFF indicator illuminates in red, and the coffee maker starts to brew normal coffee.
   NOTE : You can take out carafe, pour and serve at any time. The appliance will stop dripping automatically. But the time cannot exceed 30 seconds.

9. Remove out carafe to serve when finish brewing (about one minute later after the coffee stops dripping out.)
   NOTE : The coffee you get will less than the water you have added, as some water is absorbed by coffee ground and adhere to the plastic.

10. When the process is finished, if you do not want to serve immediately, keep the coffee maker be energized, the coffee can be kept warm on the thermal insulation plate. And the appliance will shut off automatically after 40 minutes from the ON/OFF setting being activated if it has not been manually disconnected at the completion of brewing. For an optimum coffee taste, serve it just after brewing.

11.  Always turn the coffee maker off and disconnect the power supply when not use.

NOTE : Pay attention to pour the coffee out, otherwise you may be hurt as the temperature of coffee just finished is high.

DELAY FUNCTION

if you do not want the coffee maker to start operation immediately, for example now it is 8:00, you hope that the coffee maker will automatically start working at 13:00, first follow steps 1 to 5 of “USING YOUR COFFEE MAKER ”, and then you can set the automatic start function as follows:

1. Follow the steps 6 to 7 of “USING YOUR COFFEE MAKER ” set the current time that is 8:00.
   NOTE :The time cycle is 24 hours.

2. Press to the “PROG” setting, the PROG indicator blinks in green, and the LCD display indicates “12:00” .

3. Follow the steps 6 to 7 of “ USING YOUR COFFEE MAKER ” set the automatic start time that is 13:00.

4. After setting the automatic start time, press to the “PROG” setting, the PROG indicator illuminates in green solidly. After a while, the LCD display indicates the current time
   NOTE : You may cancel the automatic start function by press to the “PROG” setting again. If you want to change the automatic start time, only following the above steps 2-3 again.

5. When the time is due, the ON/OFF indicator will illuminate in red and the appliance starts brewing. When the process is finished, if you do not want to serve immediately, keep the coffee maker be energized, the coffee can be keep warm on the warming plate. And the appliance will shut off automatically after 40 minutes from the ON/OFF setting being activated if it has not been manually disconnected at the completion of brewing. For an optimum coffee taste, serve it just after brewing
   NOTE : During delay brewing process, the settings of “HOUR” and “MIN” are invalid.

CLEANING AND MAINTAINANCE

CAUTION : Be sure to unplug this appliance before cleaning. To protect against electrical shock, do not immerse cord, plug or unit in water or liquid. After each use, always make sure plug is first removed from wall outlet.

1. Clean all detachable parts after each use in hot sudsy water.
2. Wipe the exterior surface of unit with a soft, damp cloth to remove stains.
3. Water droplets may buildup in the above area of the funnel and drip onto the product base during brewing. To control the dripping, wipe off the area with a clean, dry cloth after each use.
4. Use a damp cloth to gently wipe the thermal insulation plate. Never use abrasive cleaner to clean it.
5. Replace all parts and keep for next use.

REMOVING MINERAL DEPOSITS

To keep your coffee maker operating efficiently, periodically you should clean away the mineral deposits left by the water according to the water quality in your area and the use frequency, we recommend removing mineral deposits as follows:

1. Fill the water tank with water and descaler to the max level as indicated on the water level gauge (the scale of water and descaler is 4:1, the detail refers to the instruction of descaler. Please use “household descaler” , you may also use the citric acid instead of the descaler (the one hundred parts of water and three parts of citric acid).
2. Insert the glass carafe onto the warming plate.
3. Make ensure filter (without coffee powder) and funnel are assembled in place.
4. Turn on the appliance and allow it to “brew” de-scaling solution by follow the operation above.
5. After “brew” one-cup solution, switch off the appliance.
6. Leave the solution stay for 15 minutes and repeat step 3-5.
7. Turn on the appliance and run off the solution until the water tank is completely empty.
8. Rinse by operating the appliance with water at least 3 times.

HINTS FOR GREAT-TASTING COFFEE

1. A clean coffee maker is essential for making great-tasting coffee. Regularly clean the coffee maker as specified in the “CLEANING AND MAINTENANCE” section. Always use fresh, cold water in the coffee maker.
2. Store unused coffee powder in a cool, dry place. After opening a package of coffee powder, reseal it tightly and store it in a refrigerator to maintain its freshness.
3. For an optimum coffee taste, buy whole coffee beans and finely grind them just before brewing.
4. Do not reuse coffee powder since this will greatly reduce the coffee’ flavor. Reheating coffee is not recommended as coffee is at its peak flavor immediately after brewing.
5. Clean the coffee maker when over-extraction causes oiliness. Small oil droplets on the surface of brewed, black coffee are due to the extraction of oil from the coffee powder.
6. Oiliness may occur more frequently if heavily roasted coffees are used.

Warranty

We hereby warranty our Minimex Coffee Maker model MDC3 in a period of 1 (one) year.

Warranty Conditions

The warranty cover product defective and workmanship . Users must properly use and maintain following the instructions manual..

Warranty exceptions
We disclaims all responsibility for incidental or consequential damage caused by use of this appliance This warranty will be void if customers.

• lead to a misunderstanding of the purpose of the design, such as using product in a commercial use.
• Use the wrong way or not used as described in the instruction manual.
• no maintenance as recommended in the instruction manual.

Customer right for product warranty
The warranty is effective on the date specified in the warranty card , invoice or receipt as proof of purchase.

Determination of defective product
The company will inspect the false or defective of the product and decide that the defective of the  product is in warranty or not. The decision is solely the rights of the company. If the product proved to be defected and covered by warranty, company will be responsible for parts and labor to repair and deliver the product to customers’ house. Customers do not have to pay any fee .If the company considers that it must change its products to customers, but the same model of product is not available, the company will determine an appropriate version of the product to be replaced.

Returns of Product

If customer purchases to be dissatisfy. Customer could return the product within 15 days after purchasing date only if the product is completely perfect packaging and has not been used before. Customers must present proof of purchase to return the product at the store of purchase only

Service Center

If customer need service or information, customer can contact our Minimex Service Center
Service Center : Tel. 0-2817-8999, 02-493-6565
Fax : 0-2464-1600
E-mail : SERVICE_minimex@penk.co.th

ENVIROMENT FRIENDLY DISPOSAL

Please dispose of old machines in an environmentally neutral way. Old machines contain valuable materials which should be salvaged for recycling. Please therefore dispose of old machines via your regional collection system

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>