LUMME LU-FH713A Fan Heater User Manual

LUMME LU-FH713A Fan Heater

Parts list

1. Housing
2. Air outlet
3. Air inlet
4. Thermostat knob
5. Mode control: Room temperature air / Warm / Hot wind
6. Power indication light
7. Handle

The real set of the appliance could be different from those listed in the User manual. Check once buy.

BEFORE THE FIRST USE

CAUTION

• Read this manual carefully before using the appliance and save it for future reference. When using electrical appliances, basic precautions should always be followed, including the following:
• Before the first use, check the device specifications and the power supply in your network. Use the appliance only on the voltage specified on the identification plate.
• It is not intended for industrial use. When store your heater, keep it in a cool, dry place.
• Use the device in a well ventilated room with at least 1 meter of space on each side for normal air circulation and heat removal.
• The appliance should never be used under conditions where it may be immersed, or come in contact with water. Similarly do not plug in the appliance if its surfaces are damp.
• Do not allow the operating device to come into contact with fusible or flammable materials, fabrics, curtains, etc.
• For indoor use only. Use only for domestic purposes according to the instruction manual. Do not use or store the unit in damp and moist areas where it may come in contact with water.
• Do not place or use the unit on or near other household appliances (a hot gas or electric burner, etc.). To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
• Do not use the appliance near explosives or flammable materials and easy deformed objects.
• Do not use with damaged cord, plug or other injuries. Do not move the device by holding the cord.
• Keep the power cord away from sharp edges and hot surfaces. Do not pull the cord. Always take the socket not the wire. Do not reel the cord around the device housing.
• Never attempt to frame and repair the appliance by yourself. If you meet problems or if it has been dropped, or damaged in any manner, please contact the nearest customer service center.
• Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
• Place the appliance on a flat, stable and heat-resistant surface that can support the weight of the appliance.
• Incorrectly assembled device may cause fire, electric shock or other injury.
• NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after having not been used for a long period of time the heater may emit some smell and fumes. This will disappear after a while.
• DANGER: Do not cover the device with anything while it is in operation! Do not place any objects on it!
• To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.
• Do not touch the appliance, the power cord and the plug with wet hands! Do not insert and pull out the plug by wet hands, as this may cause electrical shock.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Keep out of the reach of children. Close supervision is required when any appliance is used by or near children.
• Maximum allowable continuous operating time is 4 hours.
• Unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use. Unplug heater by grasping plug and pulling it from the outlet. NEVER YANK ON CORD.
• Danger of electric shock exists even when the appliance is switched off. ALWAYS unplug the unit when not in use.
• WARNING: This device heats up during use. The temperature of surface may be exceeded when the appliance is in operation. The heater must always operate in vertical position.
• Do not touch the hot surfaces or heating elements inside to avoid burns. Use handle, regulator and knob.
• WARNING: Failure to observe safety precautions may result in fire, electric shock, or burns. Damage to the appliance caused by improper use will exempt the seller from warranty service.
• Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing!
• Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly, and dry.

USING THE APPLIANCE

• Make sure the device is switched off (thermostat knob to the «-» position). Insert the plug of the heater into a suitable socket.
• Set the heating mode (Power indicator light will turn on):
• «Ventilation» mode (Fan Only, Room temperature air).
• I – «Warm wind» mode at reduced power.
• II – «Hot wind» mode at full power.
• Turn the thermostat knob fully in a clockwise direction to the maximum setting.
• When the desired room temperature has been reached, the thermostat knob should be turned slowly anti-clockwise until the «click» sound.
• After this, the heater will keep the air temperature in the room at the set temperature by switching on and off automatically.
• The adjustable thermostat can be used to finely regulate the temperature. Turn the temperature control setting to the maximum to increase temperature and turn it to a minimum to decrease temperature.
• witching off: turn the knob to setting «O», and turn the thermostat knob to the «-» position. Disconnect the appliance from the power supply. Do not pull on the wire, only hold on to the plug.
• DO NOT USE THE APPLIANCE MORE THAN 4 HOURS WITHOUT A BREAK.

SAFETY SYSTEM

• To avoid damage of internal components, the heater is equipped with a safety system which will automatically switch off the appliance in case of accidental overheating.
• If this happens, the heater will automatically switch off.

If overheating occurs:

• Turn the mode control switch to «O» position and remove the plug from the socket.
• Let the fan heater cool down for a few minutes before you start it again.
• Remove the cause of overheating.
• Plug in the appliance and switch it on. If the appliance doesn’t operate normally, remove the plug from the socket immediately and contact the nearest customer service center

OVERTURN PROTECTION SYSTEM:

• The heater is equipped with tip over switch. If the heater is accidentally dropped, the heater will automatically switch off. Put the fan-heater back to the vertical position to switch it on.

CLEANING AND MAINTENANCE

• Switch off the appliance and unplug it from the power supply and allow cooling down. Wipe the outside of the appliance with a soft damp cloth. Clean the air inlet/outlet grilles regularly.
• Do not immerse the appliance in water or other liquids. Do not use any detergents or abrasives and do not allow any water to enter the heater.
• When the heater is not used for long periods of time it should be protected from dust and stored in a clean dry place.

SPECIFICATION

• Power supply Producer: COSMOS FAR VIEW INTERNATIONAL LIMITED
  • 230 V ~ 50 Hz

WARRANTY

• WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating, rubber seals, etc.)
• Production date is available in the serial number located on the identification sticker on the gift box and/or on sticker on the device.
• The serial number consists of 13 characters, the 4th and 5th characters indicate the month, the 6th and 7th indicate the year of device production.
• Producer may change the complete set, appearance, country of manufacture, warranty and technical characteristics of the model without notice.
• Please check when purchasing device.
• Current information about service centers is available on the website http://lumme-ru.com.
• Room 701, 16 apt, Lane 165, Rainbow North Street, Ningbo, China Made in China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>