LUMME LU-3834 Electric Thermo Pot User Manual

May 15, 2024
LUMME

LUMME LU-3834 Electric Thermo Pot

LUMME-LU-3834-Electric-Thermo-Pot-product

DESCRIPTION

LUMME-LU-3834-Electric-Thermo-Pot-fig-1

  1. Lid opening lever
  2. Pump
  3. Handle
  4. Water gauge
  5. Control panel
  6. Housing

TECHNICAL SAFETY

When using electrical appliances, basic safety precautions should always be observed including the following:

  1. Before connecting the appliance, check if the voltage indicated corresponds with the mains voltage in your home.
  2. To protect against electrical shock do not immerse the body, cord or plug in water or other liquid.
  3. Place the airport on a flat surface, at least 30 cm away from the stove or other heat source.
  4. Do not fill any liquid except clean water.
  5. Do not fill water directly from a tap water faucet. Use a pitcher or kettle to keep electrical parts safe from splashes of water.
  6. Never plug into the power source without filling the pot with water. Do not overfill the pot with water and always check if the water level needs a new supply.
  7. Avoid splashes of water on the airpot’s body especially on the top portion to prevent electrical shocks. In accidental case of water splashes, wipe it dry immediately.
  8. Do not let the cord hang over the edge of the table or counters, or touch hot surfaces.
  9. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner.
  10. In case of a damaged mains cord, it must be replaced by a repair shop authorized by the manufacturer.
  11. Keep the airport away from children, handicapped and elderly persons. They should be supervised if they are going to dispense water from the air to prevent accidents and burn injuries.
  12. Unplug from the outlet when not in use and before cleaning. Allow to cool before putting or taking off parts.

OPERATION

Tips and reminders when filling water:

  • Never fill water in excess. Doing so will cause water to overflow when boiling and may damage the body while heating water. It may also damage the airport after a short period.
  • Never fill water directly from a tap water faucet to avoid short-circuit and electrical shock.
  • Be sure to close the top cover and lock it. Note: Closing the top cover creates a clicking sound.
  • Plug it into the power source. The red indicator lights up to indicate the heating process.
  • Never open the top cover or fill the airport with water during boiling. Do not cover the steam vent.
  • When water has boiled, the red indicator turns off and the green indicator lights on signalling the keep warm state (temperature approximately 98°C).
  • When dispensing hot water, press the pressure pad with enough force to bring out water from the airport.
  • Exercise caution and extreme care when dispensing hot water from the airport to prevent accidents and burn injuries.
  • Press the lid opening switch to unlock the lid’s top cover and open it. Pour water into the airport up to the “MAX” watermark.
  • Close the top cover and lock it. Closing the top cover creates a clicking sound.
  • Plug it into the power source. The red indicator lights up to indicate the heating process.
  • When water has boiled, the red indicator turns off and the green indicator lights on signaling the keep warm state (temperature approximately 98°C).
  • When dispensing hot water, press the pressure pad with enough force to bring out water from the airport.

CLEANING AND MAINTENANCE

When cleaning the airport, make sure to unplug it from the power source and that the hot water has cooled down completely before taking it out from the airport. It is advisable to clean the air inside and outside
before using it for the first time. Cleaning the airport is scheduled once a month or as desired to ensure water quality and lengthen the service life of the inner pot. When the airport is not going to be used for a long time, it should be cleaned and dried before sealing it in a plastic bag and stored in a safe, dry place.

TECHNICAL SPECIFICATION

  • Power supply 230 V ~ 50 Hz

WARRANTY DOES NOT APPLY TO CONSUMABLES (FILTERS, CERAMIC AND NON-STICK COATING, RUBBER SEALS, ETC.)
The production date is available in the serial number located on the identification sticker on the gift box and/or on the sticker on the device. The serial number consists of 13 characters, the 4th and 5th characters indicate the month, and the 6th and 7th indicate the year of device production. Producer may change the complete set, appearance, country of manufacture, warranty and technical characteristics of the model without notice. Please check when purchasing the device.
MANUFACTURER: COSMOS FAR VIEW INTERNATIONAL LIMITED, ROOM 701, 16 APT, LANE 165, RAINBOW NORTH STREET, NINGBO, CHINA

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals