SEACHOICE 19403 Universal Float Switch Instruction Manual
- September 11, 2024
- SEACHOICE
Table of Contents
SEACHOICE 19403 Universal Float Switch
Product Information
Universal Float Switch
This Float Switch is designed to make any DC Bilge Pump automatic. It ensures efficient water flow management in the bilge area.
Specifications:
- Product Type: Float Switch
- Compatibility: DC Bilge Pump
- Material: Durable plastic
- Installation: Surface mount
Product Usage Instructions
Installation Instructions:
- Locate a flat surface in the bilge that is at least 1/4 higher than the strainer base of the bilge pump.
- Mount Float Switch with screws provided.
- Connect wires as shown in the wiring diagram. If replacing a float switch, reconnect wires to the new switch.
- Keep all wire connections above the highest water level and seal with marine-grade sealant.
NOTE: Regularly clean debris from around the switch or integral switch guard. This will allow water to flow freely to the float.
IMPORTANT: Keep all wire connections above the highest water level. Wires should be sealed with a waterproof marine sealant to prevent corrosion.
Frequently Asked Questions
- Q: How do I ensure the proper functioning of the Float Switch?
- A: Regularly clean debris from around the switch and ensure wire connections are sealed with marine-grade sealant above the highest water level.
- Q: Can this Float Switch be used with any type of bilge pump?
- A: This Float Switch is designed for use with DC Bilge Pumps.
Installation Instruction
This Float Switch will make any DC Bilge Pump Automatic. To mount the Float Switch.
- Locate a flat surface in the bilge that is at least 1/4″ higher than the strainer base of the bilge pump.
- Mount Float Switch with screws provided.
- Connect wires as shown in the wiring diagram. If you are replacing a float switch, reconnect wires to the new switch.
- Keep all wire connections above the highest water level and seal with marine-grade sealant.
NOTE: Regularly clean debris from around the switch or integral switch guard. This will allow water to flow freely to the float.
KEEP ALL WIRE CONNECTIONS ABOVE THE HIGHEST WATER LEVEL. WIRES SHOULD BE SEALED WITH A WATERPROOF MARINE SEALANT TO PREVENT CORROSION
“`