MITSUBISHI ELECTRIC TPEFYW027MA1W0A HVRF Ducted System Owner’s Manual
- September 11, 2024
- Mitsubishi Electric
Table of Contents
MITSUBISHI ELECTRIC TPEFYW027MA1W0A HVRF Ducted System
Product Usage Instructions
Installation:
- Ensure proper spacing for maintenance at the bottom of the unit.
- Use an M10 screw for suspension bolt installation.
- For units with multiple fans, follow the specific instructions provided.
Maintenance
- Regularly clean or replace the air filter as needed.
- Check drain pipes and lift mechanism for any blockages or Vleaks.
Operation:
- Use the appropriate HBC Controller for system control.
- Ensure proper water pipe connections for efficient operation.
Frequently Asked Questions
-
Q: What should I do if the unit is not cooling/heating properly?
A: Check the air filter for blockages and ensure proper airflow. Additionally, verify that the power source is stable and the settings are correct on the HBC Controller. -
Q: How often should I clean the air filter?
A: It is recommended to clean or replace the air filter every 1-2 months depending on usage and environmental conditions.
Job Name:
System Reference:
Date:
GENERAL FEATURES
- Dual set point functionality
- Multiple fan speed settings
- Auto fan mode
- 9-7/8” (250mm) high for low ceiling heights
- uilt-in condensate lift; lifts to 27-9/16” (700 mm)
- Ducted fan coil supporting multiple configurations for flexible installation
- Hydronic-based indoor coil
- Built-in Manual Air Vent
Specifications
| Specifications | System |
|---|---|
| Unit Type | TPEFYW027MA1W0A |
| Cooling capacity (Nominal)1 | BTU/H |
| Heating capacity (Nominal)1 | BTU/H |
| Power source | Voltage, Phase, Hertz |
Power Consumption
| Cooling| kW| 0.142
Heating| kW| 0.140
Current
| Cooling| A| 1.24/1.12
Heating| A| 1.24/1.12
MCA| A| 2.88/2.88
Maximum Overcurrent Protection (MOCP)| A| 15
Recommended Fuse Size| A| 15
External finish| Galvanized Steel Plate
External Dimensions| In. [mm]| 43-5/16 x 28-7/8 x 9-7/8 [1,100 x 732 x 250]
Net weight| Lbs [kg]| 67 [30]
Heat exchanger| Cross fin (Aluminum fin and copper tube)
Fan
| Type x quantity| Sirocco fan x 2
External Static pressure
|
in.WG
| Selectable;
0.14, 0.2, 0.28, 0.4, 0.6 In. WG;
factory set to Factory set to 0.2 In. WG
Airflow rate| CFM| 618–742–883
Motor type| DC brushless motor
Motor Output| kW| 0.121
Motor FLA| A| 1.4
Sound pressure level (Measured in anechoic room)| dB(A)| 31–35–39
Air filter| PP Honeycomb fabric (washable)
Diameter of drain pipe| In. [mm]| O.D. 1-1/4 [32]
Drain lift mechanism| In. [mm]| 27-9/16 [700]
Connectable HBC Controller| CMB-WP-NU-AA, CMB-WP-NU-AB
Design Pressure| PSI (Mpa)| 145/1
Diameter of Water Pipe Connections (O.D.)
| Supply Connection (O.D.)| mm| 22
Return Connection (O.D.)| mm| 22
Water Volume| Gallons (Liters)| 0.554 (2.1)
NOTES:
- Cooling | Indoor: 81° F (27° C) DB / 66° F (19°C) WB; Outdoor 95° F (35° C) DB
- Heating | Indoor: 68° F (20° C) DB; Outdoor 45° F (7° C) DB / 43° F (6° C) WB
ACCESSORIES
INDOOR UNIT ACCESSORIES: TPEFYW027MA1W0A
| Control Interface | Deluxe Wired MA Remote Controller | □ TAR-41MAAU |
|---|
Wired Remote Controller
| Simple MA Remote Controller†| □ TAC-YT53CRAU-J
Smart ME Remote Controller – Backlit touchscreen| □ TAR-U01MEDU-K
Touch MA Controller†| □ TAR-CT01MAU-SB
Wireless Remote Controller
| Wireless MA Remote Controller| □ TAR-FL32MA-E
Wireless Remote Contoller| □ PAR-SL101A-E
Condensate
| Blue Diamond (Advanced) Mini Condensate Pump w/ Reservoir & Sensor
(208/230V) [recommended]| □| X87-721
Blue Diamond (MaxiBlue Advanced) Mini Condensate Pump w/ Reservoir & Sensor
(110V) up to 48,000 BTU/H [recommended]| □|
X87-711
Blue Diamond (MegaBlue Advanced) Condensate Pump w/ Reservoir & Sensor| □|
X87-835
Blue Diamond Alarm Extension Cable — 6.5 Ft.| □| C13-192
Blue Diamond MultiTank — collection tank for use with multiple pumps| □|
C21-014
Blue Diamond Sensor Extension Cable — 15 Ft.| □| C13-103
Drain Pan Level Sensor/Control| □ SS610E
Sauermann Condensate Pump| □| SI30-230
Control Interface
| 3-Pin Connector| □ PAC-715AD
CN24 Relay Kit| □ CN24RELAY-KIT-CM3
Connector and wire for Operation status/error using CN51| □ PAC-725AD
Disconnect Switch| (30A/600V/UL) [fits 2” X 4” utility box] – White| □ TAZ-
MS303W
Filter Box| Filter Box with MERV 13 Filter| □ FBM2-3-A
HBC Controller
| Hybrid VRF Main BC 16 Port| □ TCMBM1016VA11N4
Hybrid VRF Main BC 8 Port| □ TCMBM0108VA11N4
Hybrid VRF Sub BC 16 Port| □ TCMBS1016VB11N4
Hybrid VRF Sub BC 8 Port| □ TCMBS0108VB11N4
HVRF Accessories
| (2x) Isolation Ball Valve and (2x) 22mm Compression Fitting| □
KIT2-NA10883-CAL
25mm Isoflow Multi, 25m Coil w/ 1” Titan| □| 13630061001-REH
25mm PVDF SDR11 Sleeve (Box QTY 50)| □| 11803271001-REH
25mm SDR11 Coupling (Bag QTY 10)| □| 11690101001-REH
25mm SDR11 Elbow (Bag QTY 10)| □| 11691261001-REH
25mm SDR11 x 3/4” FPT Fitting (Bag QTY 1)| □| 15012451001-REH
25mm SDR11 x 3/4” MPT Fitting(Bag QTY 10)| □| 15012461001-REH
25mm x 25mm x 25mm SDR11 Tee(Bag QTY 10)| □| 11690561001-REH
25mm x 25mm x 25mm SDR11 Tee(Bag QTY 10)| □| 15012471001-REH
40mm Isoflow Multi, 5m Stick w/ 1.5” Titan| □| 13630071001-REH
40mm PVDF SDR11 Sleeve (Box QTY 25)| □| 11803291001-REH
40mm SDR11 Coupling (Bag QTY 5)| □| 11690151001-REH
40mm SDR11 Elbow (Box QTY 1)| □| 11691301001-REH
40mm SDR11 x 3/4” MPT Fitting (Box QTY 1)| □| 15012481001-REH
40mm x 40mm x 25mm SDR11 Tee (Bag QTY 1)| □| 11690691001-REH
Compact Discal AAV w/ Hydroscopic Cap and Drain Plug| □ KIT3-NA10884-CAL
Copper Press Tailpieces (3/4”)| □ KIT5-NA10881-CAL
Drain Valve w/ Brass NPT T-Fitting| □ KIT4-NA10885-CAL
RAUTOOL A-Light2 Kombi Tool KIT| □| 11094491001-REH
DIMENSIONS
INDOOR UNIT DIMENSIONS: TPEFYW027MA1W0A
TPEFYW06, 08, 12, 15, 18, 24, 27, 30, 36, 48MA1W0A
Unit: mm (in.)
FORM# TPEFYW027MA1W0A – 202405
Specifications are subject to change without notice.
© 2024 Mitsubishi Electric Trane HVAC US LLC. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>