K S 7686 Ground Spot LED Instruction Manual
- June 3, 2024
- K S
Table of Contents
Grondspot | Rond Ø22,5 Led zwart – 7686
Assembly and installation instructions
- Connection and maintenance of the luminaire must be carried out by trained and qualified technicians only, in compliance with the regulation in force.
- Make sure there is no power connected to the fitting before carrying out any maintenance
- LED risk group 0-1 IEC 62471. Do not stare at operating luminaire. It may be harmful to the eyes.
- Place the inground luminaire on a 20-30cm drainage layer (gravel) and fill it with water, if after 30 minutes water is still in the luminaire it is compulsory to integrate an additional draining system (e.g. drain pipe).
- To avoid water stagnation, do not place the inground luminaire for installation on hollow areas.
- If you disassemble the inground luminaires, projectors or bollards. Make the luminaires working for 30-60 minutes before to assemble them. In order to avoid the measure.
- The protection rating of the electrical connection for the luminaires with factory pre-wired connection cable must be equal to or greater than the IP67.
- The protection rating of the electrical connection for projectors must be equal to or greater than the IP67
- The protection rating of the electrical connection for inground luminaires must be equal to or greater thathe IP67
- All luminaires are equipped with a H20 STOP system giving effective protection against water or moisture passage along connecting cables.
- If the external flexible cable or cord of the luminaire is damaged, it shall be exclusively replaced by the manufacturer or qualified technician, in order to avoid a hazard.
- Tighten and release screws alternatively or cross wise.
- For an easy maintenance (unscrewing) of the luminaire we recommend protecting screws threads with silicone grease before exposure to weather.
- Keep the luminaire clean to prevent dirty deposit on frames and screws’ head. On stainless steel parts use dedicated cleaners only.
- Keep away from aggressive agents and chemical substances (e.g. fertilize, weed-killer, lime)
- Do not use water high pressure cleaners.
- Electronical equipment sensitive to voltage surges. The installation of a protection device against overvoltage on the electrical system attenuates the intensity of these phenomena protecting apparatus from the risk of damage.
- In case of diffuser damage change it before to switch on the fitting.
Grondspot | Rond Ø18,5 Led- zwart – 7685 | Rond Ø22,5 Led- zwart – 7686 | Rond Ø27 Led- zwart – 7687
The drawings are for illustrative purposes only. They may vary in model of the lamp.
www.ks-verlichting.nl
Februari 2021
Documents / Resources
| K S
7686 Ground Spot
LED
[pdf] Instruction Manual
7686 Ground Spot LED, 7686, Ground Spot LED, Spot LED, LED
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>