Andeman 14-50 Circuit Analyzer User Manual
- September 7, 2024
- Andeman
Table of Contents
Andeman 14-50 Circuit Analyzer
- POWER ON
- OPEN NEUTRAL
- OPEN GROUND
- MISSING L 1 120V
- MISSING L2 120V
- REVERSE POLARITY
- L 1 & GND REVERSED
- L2 & GND REVERSED
- OPEN CIRCUIT
Instructions to Use
- Plug in the Surge Guard XCTSPSO-A into an approved RV receptacle and plug the RV power cord into the Surge Guard.
- Verify that all three top LED indicator lights are ON and GREEN. This indicates that you have good electrical power at the pedestal in your location.
- If any of the three top LED indicator lights are not ON or RED, refer to the diagram on the front of the Surge Guard unit, or in this instruction sheet, to determine the fault condition you may have atthe power pedestal.
- If a fault condition is indicated, there may be a problem with the pedestal wiring or with the power at your location. Consult a licensed electrician to correct the fault condition or move RV and connect to a different pedestal.
- If SURGE PROTECTION green LED indicator light is off, there is no surge protection.
- If OVER HEAT WHEN ON red LED indicator light is on, unit is overheating.
Product Overview
Technical Data
- Voltage 120/24 0Volts AC
- Current Rating(Load) 50 Amps
- Frequency 50/6 0 Hz
- Surge Energy 12000 joules
CAUTION
- Fully insert plug
- Keep away from c hildren and pets
- Do not repair or modify
- Store indoors when not in use
Integrated Surge Protection
- Diagnostic lights for visual indication of incorrect wiring faults
- Weather resistant
DO NOT SUBMERGE IN WATER
WARNING: This device designed solely for marine, recreational vehicles
and mobile home use and is not for use with any other adapter or device.
Adapter must be used in conjunction with a circuit breaker rated 50 AMP,
120/240 VAC. Our liability is limited solely to the replacement of any
defective product returned to us. We make no other warranty.
WARNING: Cancer and Reproductive
Harm – www.P65Warnings.ca.gov
FCC statement:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Andeaam Model: 14-50
N 14-S0P/N 14-S0R
120/240 VOL TS-50A
Contact Us: andeman.com
Documents / Resources
|
Andeman 14-50 Circuit
Analyzer
[pdf] User Manual
l14-50-rv-surge-protector-50a, 14-50 Circuit Analyzer, 14-50, Circuit
Analyzer, Analyzer
---|---