Taimei Bath 2032 Round Framed Mirror Instruction Manual
- September 9, 2024
- Taimei Bath
Table of Contents
Taimei Bath 2032 Round Framed Mirror
HARDWARE AND TOOLS
-
1/4″ & 1/8″ Drill Bits
-
Pencil
-
Level
-
Power Drill
-
Mallet
-
Tape Measure
-
Safety Goggles
PRODUCT FUNCTION INSTRUCTIONS
Touch key to turn on/off
defogging function.When defogger is on, the button should be in blue color.
The anti-fog function can only be used after 5 minutes of turning on, and will
automatically cancel after 60 minutes of standby. If extended use is required,
it must be re-enabled.
After power on, the button
shows blue and it is in waiting state.
The lighting color
temperature will be changes with each short press
Click the light button to turn on and the color changes to white
Click again to change the light color
Click the fourth time to turn off the light
Long press to adjust the
brightness
Long press to make the light gradually dims
Long press to again and the light gradually brightens
When you adjust your favorite color temperature, long press the button, you can adjust the brightness of the color temperature, click again, you can adjust to another color temperature.
Memory function: The
medicine cabinet will record the color temperature and brightness of your last
use. When you turn off the color and brightness after using it last time, when
you use it again, it will return to the state you used last time, no need to
adjust it again and waste time every time.
Connect the wire to Junction Box inside the wall
The electric wire comes through the access hole on the top of the cabinet, exact location of access hole varies depending on the product models. Please refer to the actual product for the exact location.
ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN
WARNING: Shut off power before wiring the cabinet. Requires 120 VAC 20 Amp GFI protected Circuit.
GROUNDING INSTRUCTIONS:
CAUTION: This product must be connected to a grounded metal permanent
wiring system or an equipment-grounding conductor must be run with the circuit
conductors and connected to the equipment grounding terminal or lead on the
product.
WARNING: An Electrical option cabinet must be wired to a 20 Amp GFI
(Ground Fault Interrupter) protected circuit when used in bathrooms and all
other locations required by the National Electric Code.
Installation Instructions
Step 1
Use the tape measure the height,and draw the horizontal, line and the vertical
in of the wash-basin.Measure the distance of the mirror hole. and mark the
hole place on the wall.
Step 2
Drill and insert the Wall Anchor Drive in the screw cross the bottom support.
Step 3
Align the holes of the mirror with the screws and hang them to complete the
installation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>