RONA WF-DB96102H 10 Inch Black Built In Shower Faucet System Instruction Manual

Table of Contents

Check the accessories list to verify that all parts are complete in this package.
Do not disassemble the main body by yourself.
Connect inlet pipes to supply valves.
Make sure inlet pipes and supply valves have no impurities and are cleaned, with no impurities in the pipeline.
After installation, check all joints for leakages.
Do not leave the rain shower system exposed to a severely corrosive environment.

YOU MAY NEED:

Two-function Rain Shower System Model: A

No.	Part name	Qty		No.	Part name	Qty
1	Showerhead	1		11	Main body	1
2	Shower arm	1		12	Water diverter cap	1
3	Shower arm cup	1		13	Water diverter screw	1
4	Hand shower holder	1		14	Handle screw	1
5	Holder cup	1		15	Handle wrench	1
6	Show hand	1		16	Handle cap	1
7	Shower hose	1		17	Main body spare parts	4
8	Water diverter	1		18	Instruction manual	1
9	Handle	1		19	Gloves	2
10	Deck Plate	1
---	---	---	---	---	---	---

Essential dimensions & water pipeline

The installation depth of the shower holder and body jet

The thickness of the tile must be calculated for installation.

Installation Depth Of Main Body

Notice:

The installation depth of the main body should be no less than 2 9/16″ (65mm) and no more than 2 15/16″ (75mm), including the thickness of the tile. Otherwise, the deck plate cannot be installed.
The opening size of the ceramic tile shall be smaller than the deck plate size.

Piping Instructions Before Tiling

As shown in the figure, the inlet and outlet pipes are pre-buried. Please pay attention to the correct direction when installing the pre-buried main body.
Before tiling, turn on the water to test whether the left and right inlet pipes are tightly connected without leakage. Then, adjust the flow switch to the “on” position to check for leaks in the mixed outlet pipes.

Main Body Valve Installation

Make marks according to the size of the main body valve, and then drill anchors into the wall (concrete wall).
Lock the main body to the wood directly with screws (wood wall).
When installing the main body, please mark the UP side up and do not install it upside down.
- Please note that the level meter should be parallel to the wall; otherwise, the deck plate cannot be installed.

Installation of the Hand Shower Holder

Connect the shower arm with the cover before screwing the arm into the riser connection to prevent damage.
Fix the shower head onto the shower arm and apply tape to the pipe threads on both ends.
Do not over-tighten the shower head. It is a 360° swivel connection.

Installation The Hand Show Holder

Do’s

ln order to keep the mixer surface bright, please clean the mixer regularly.
Rinse the faucet with clean water and wipe it with a soft cotton cloth.
Use one of the following cleaners to remove dirt from the surface:
- a. Mild liquid cleaner.
- b. Colorless glass cleaner and powder cleaner that does not cause abrasion and can be dissolved completely.
- c. Polish liquid that does not cause abrasion.

Don’ts

a. Avoid using cleaning powder, harsh cleaning chemicals, brushes, and coarse cloth to prevent scratching and friction.
b. Do not use acid cleaners to clean the faucet as they may cause surface corrosion of the faucet. If the faucet is exposed to harmful acid substances, please rinse it immediately with water.