23 ZERO Saber Super Lite Hardshell Roof Top Tent User Manual
- August 31, 2024
- 23 ZERO
Table of Contents
Saber Super Lite Hardshell Roof Top Tent
Product Information
Specifications
- Product Name: Saber Super Lite Roof Top Tent
- Manufacturer: 23 ZERO
- Warranty: 2 years
Product Usage Instructions
Safety & Warnings
DO NOT CLIMB ON LADDER UNTIL CORRECT ANGLE IS ACHIEVED. The
manufacturer shall not be liable for special, indirect incidental,
or consequential damages.
Hardware & Accessories
The Saber Super Lite Hardshell roof top tent comes with a
mounting kit that includes everything needed to mount the tent to
most roof racks. For wider platform style roof racks, wider
mounting plates are available.
Fitting to Roof Rack
It is recommended to attach the Saber Super Lite directly to a
full-length platform-style rack or flat rack. Ensure proper
stability by supporting the tent rails with planks or multiple
cross members along the rack.
Ladder Adjustment
Adjust the ladder height until it locks in the downward
position. If further adjustment is needed, repeat the process by
depressing the next set of locking buttons.
Opening & Set Up
-
Securely fix the Saber Super Lite to the vehicle’s roof
rack. -
Lock and angle the ladder correctly.
-
Climb the ladder and release the locks at the front and rear of
the tent. -
Lift until the gas struts take over and open the tent.
-
Lower the perimeter shock cord and hook it to both front
corners of the baseboard. -
Unzip the entry door and enter the roof top tent.
-
The tent is now ready for use.
Closing & Storage
Follow the reverse steps to close the tent after use. Store the
tent as per manufacturer’s instructions to ensure longevity.
FAQ
Q: Can I leave the tent attached to the vehicle while
driving?
A: It is not recommended to travel with the tent open. Close and
secure the tent before driving.
Q: How do I clean the tent?
A: Use a mild soap solution and water to clean the tent fabric.
Avoid using harsh chemicals that may damage the material.
TM
USER MANUAL
TM
SABER SUPER LITE USER MANUAL
Thank you for purchasing a 23 ZERO Roof Top Tent
Congratulations on the purchase of 23ZERO’s Saber Super Lite Hardshell Roof
Top Tent. We strive to provide you with the ultimate camping experience. The
Saber Super Lite Tent mounts directly to a roof rack or aftermarket roof bars.
It opens and is fully setup in seconds. As well as our innovative LST fabric,
this hardshell tent is made with durable materials and high-quality fabrics
that provide excellent water and wind protection. Most of the components have
been pre-assembled with the exception of ladder brackets, awning stay pole
brackets and roof bars. Depending on vehicle set up and choice of entry
points, these components can be repositioned to suit.
Note: During set up and first use, some aluminium swarf may be present inside
the roof top tent. We make every possible attempt to expel all aluminium
swarf, however, with vibrations caused by logistics some residual may dislodge
and reappear. It is advised to remove and clean these during first set up.
PLEASE READ ALL INSTRUCTIONS PRIOR TO INSTALLING
IMPORTANT
Before installing your 23Zero Roof Top Tent please ensure you are aware and
understand the following: · Your vehicle’s maximum roof load rating. · Your
roof rack’s maximum load rating including off-road capacity. The maximum
amount of weight you can safely add to a vehicle’s roof / cargo area differs
according to make and type of vehicle including aftermarket additions such as
roof racks / bars. Note: Roof rack off-road limits are immensely different to
normal road use load ratings. If in doubt, please contact your vehicle
manufacturer and roof rack manufacturer / supplier for specified loading
capacity of your vehicle and roof rack. Not all factory roof racks or
aftermarket roof bars can safely accommodate roof top tent models. The
responsibility of fitting this roof top tent to rated roof racks or roof bars
lays with the purchaser.
CONTENTS
Safety & Warnings
2
Hardware & Accessories
3
Fitting to roof rack
4
Roof Bars
6
Ladder adjustment
7
Opening & Set up
8
Closing & Storage
8
Warranty
9
1
TM
SABER SUPER LITE USER MANUAL
Safety & Warnings
Improper installation or use of the Saber Super Lite roof top tent may result
in serious injury or death. Follow these installation instructions carefully
to ensure proper installation to vehicle and safe use of the roof top tent.
Note: Alterations and / or inclusions such as roof racks and roof top tents
applied to the vehicle roof may affect vehicle handling and characteristics.
The manufacturer (23ZERO) disclaims all responsibility in case of accidents
and / or damage due to installation of a roof top tent to an underrated roof
rack, improper use, improper maintenance or checking the tightness of the
brackets regarding the installation of the roof rack system. Inspections: Roof
top tents have many moving parts, so maintenance checks are always advised.
During trips regularly check that all nuts and bolts attaching the roof top
tent to the vehicle as well as hinges and locks are tight and in good repair.
Ladder: For your safety and protection, ensure correct placement and angle of
ladder. Recommended ladder placement is a 4:1 ratio or approx. 75°. Ladder
height may need to be adjusted depending on vehicle height, see “Ladder
Adjustment”
DO NOT CLIMB ON LADDER UNTIL CORRECT ANGLE IS ACHIEVED 23Zero – The wholesaler
/ manufacturer shall not be liable for special, indirect incidental or
consequential damages.
2
TM
SABER SUPER LITE USER MANUAL
Hardware & Accessories
The Saber Super Lite Hardshell roof top tent includes a mounting kit with
everything required to mount the roof top tent to most roof racks.
Note: Some platform style roof racks have platforms which are wider than the
supplied mounting plate. 23ZERO have wider mounting plates available for this
scenario.
Please visit www.23zero.com.au. 3
TM
SABER SUPER LITE USER MANUAL
Fitting to roof rack
Recommended and efficient installation of the Saber Super Lite. The Saber
Super Lite is designed to be attached directly to a full-length platform-style
rack or flat rack. For proper stability, the tent rails should be supported by
planks or multiple cross members along the rack.
ENSURE TENT IS CLOSED AND OVER THE CENTRE LATCHES ARE FULLY SECURED DURING
FITMENT Secure the four corners using the provided 8 x M8 bolts, 8 slide
plates, and 4 mounting saddles. Lift the roof top tent onto the vehicle’s roof
rack, making sure that at least four individuals are involved in the lifting
process. Insert the 8 x M8 bolts into the 8 slide plates and slide each into
the bottom mounting rail. Position them so that there are two sets of bolts in
each corner of the tent. Lift or tilt the roof top tent to facilitate the
inner bolts crossing over onto the inside of the roof bars. Please refer to
the picture below for visual guidance. Note that in this process, the mounting
plate is replaced by the mounting saddle.
4
TM
SABER SUPER LITE USER MANUAL
Inspect the position of the roof top tent to ensure it will open unobstructed
in the desired orientation. Note: It is recommended that the rear of the tent
aligns flush with the back of the vehicle to ensure the correct ladder angle.
Place a mounting saddle under each roof bar while aligning the bolts. Insert
washers and handtighten Nylock nuts. Repeat this process for all four corners.
Double-check the tent’s position as desired and securely tighten all nuts
using a 13mm spanner. Insert end caps into the ends of the mounting rails;
this may require gentle taps from a hammer. Periodic inspections: Roof top
tents have various moving parts, so regular maintenance checks are advisable.
During trips, routinely inspect and ensure that all the above fixings are
torqued and in good condition.
5
TM
SABER SUPER LITE USER MANUAL
Roof bars
Note: The roof bars supplied with the Saber Super Lite roof top tent are not
designed to carry significant loads. A maximum of 10kg can be carried on top
of the Saber Super Lite providing this weight is spread evenly amongst the 2
bars. When adding additional weight to the top of the Saber Super Lite
consideration must be given to the overall weight rating capacity of your
vehicle’s roof and roof rack. Please ensure you are aware and understand the
following: · Your vehicle’s maximum roof load rating. · Your roof rack’s
maximum load rating including off-road capacity. The maximum amount of weight
you can safely add to a vehicle’s roof / cargo area differs according to make
and type of vehicle including aftermarket additions such as roof racks / bars.
Important: Before each trip please check that all roof bar and bracket fixings
are tight and in good order before adding load.
6
TM
SABER SUPER LITE USER MANUAL
Ladder adjustment
For your safety and protection, ensure correct placement and angle of ladder.
See diagrams below. Recommended ladder placement is a 4:1 ratio or approx. 70°
to 75°. NOTE: Under no circumstances should anyone be inside the roof top tent
if the ladder is not locked and secured at the correct angle.
The ladder may need to be adjusted to achieve the correct angle depending on
the height of your setup. If shortening is required, the adjustment must be
done from the top. Ensure the ladder is fully extended and all rungs are
locked in place. Press the first set of locking buttons (second rung from the
top) and allow the ladder to compress until a gap of approx. 85mm is achieved
between rung 1 & 2. Note: The ladder will only lock in the downward position.
Swing in the bottom of the ladder until it supports the weight of the roof top
tent. If the angle of the ladder is between 70° and 75°, the adjustment is
complete.
If further shortening is required press the second set of locking buttons
(third rung from the top). This will close the 85mm gap until rung 1 & 2 are
now touching. Swing in the bottom of the ladder until it supports the weight
of the roof top tent. If the angle of the ladder is between 70° and 75°, this
adjustment is complete.
NOTE: When height adjusted, the ladder will only lock in the downward
position. If further adjustment is required, repeat the above steps by
continuing the sequence by depressing the next set of locking buttons.
7
TM
SABER SUPER LITE USER MANUAL
Opening & Set up
Once the Saber Super Lite is fixed securely to the vehicle’s roof rack and the
ladder is locked and angled correctly, climb the ladder, release the locks
front and rear of tent and lift until the gas struts take over. Once open,
lower the perimeter shock cord and hook this to both front corners of the
baseboard. Unzip entry door and enter the roof top tent. The tent is now ready
for use.
Closing & Storage
Sleeping bags, blankets or additional bedding including mattress toppers can
not be stowed inside the Saber Super Lite due to its low profile design An
external perimeter shock cord is included with your Saber Super Lite hardshell
roof top tent. These assist in reducing the canvas from billowing during pack
up. Exit the tent, lift the perimeter shock cord halfway up the canvas
ensuring it goes over the canopy canvas as well. The tent is now ready to
close. Tip: Leave the side windows open halfway open to allow internal air to
escape while closing the tent. As the Saber Super Lite is closing, tuck the
canvas inside so none is caught between the sealing rubbers on the roof lid
and baseboard. Engage the locks. Unhook the ladder, retract and stow in carry
bag. Caution: Avoid closing / storing tent wet. If conditions dictate that you
do, open and dry out as soon as possible to avoid moisture damage.
8
TM
SABER SUPER LITE USER MANUAL
2 Year Warranty
23ZERO will replace or repair any product at its discretion that is subject to
faulty manufacturing or workmanship including materials. Exclusions The above
warranty is limited to manufacturing and materials defects. Not including
damage caused by misuse or abuse, wear and tear, condensation, extreme
weather, accidents, incorrect set up, damage caused by mould, insects, animals
or children. This also excludes broken poles and damage caused by a jammed,
snagged zipper or excessive force applied to zipper causing failure. Consumer
rights Our goods come with guarantees that cannot be excluded under Australian
law. You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have goods repaired or replaced if the goods fail to be of
acceptable quality and failure does not amount to a major failure. * Due to
our policy of continual product development, the specifications, colours and
features may vary. Making a claim To make a claim in relation to the above
manufacturers warranty please ensure you retain your sales receipt of
purchase. Please contact us stating the nature of your claim and we will be in
touch with you shortly. If you require additional assistance, please phone 03
9547 4691 to discuss and arrange your claim. Product subject to warranty will
be sent to 23ZERO Australia, 32b Eileen Rd. Clayton South, Victoria 3169. All
freight costs associated with return of product for assessment is payable by
consumer.
9
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>