Voyager WVTX2AP Digital Wireless Transmitter Instruction Manual

Voyager WVTX2AP Digital Wireless Transmitter Instruction Manual

WVTX2AP

Digital Wireless Transmitter Featuring
WiSight®2.0 Technology With Auto-Pair.

INSTALLATION

1. Mount the transmitter using 4 screws in a safe location to avoid impacts.
2. Connect 12 volts to the red wire and chassis ground to the black wire.
3. Connect the camera cable.
4. Secure all wires and cables.

GPIO FUNCTION

The GPIO cables are general purpose input/output +12V signals than can transmit signals wirelessly to/from the receiver side.

WIRING DEFINATION

GPIO Cable

• Yellow – GPIO Input 1 • Purple – GPIO Input 2
• Gray – GPIO Output 1 • White – GPIO Output 2

FCC NOTES

IMPORTANT NOTE:

To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device. Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

NOTICE 1:

The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTICE 2:

Our WiSight 2.0 wireless technology operates at nearly the same performance level as a wired system. However, slight delays and signal reductions are possible due to application or environmental factors.
It is recommended to maintain at least three feet in between any RF transmitting/receiving devices including the WiSight 2.0 components.This can include, but not limited to, in-vehicle Wi-Fi systems,    personal Wi-Fi hotspots, Bluetooth devices or additional wireless monitors & cameras.
If you have a Voyager WiSight 2.0 Digital Wireless Observation Systems along with any other device that transmits or receives and you are experiencing difficulty in operating the system, the device(s) may be too close to either the WiSight 2.0 Monitor or Camera.
Change the placement to at least three feet between devices and re-test for proper operation.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>