vtech 539800 Sleepy Sounds Baby Bear Instruction Manual

539800 Sleepy Sounds Baby Bear
Instruction Manual

INTRODUCTION

Thank you for purchasing the Sleepy Sounds Baby Bear™!
Sleep is at the top of the wish list when there’s a baby or toddler around.
This bear is here to help! White noise, nature sounds and a soothing heartbeat make this cuddly bear a welcome friend in the nursery and on the go.

INCLUDED IN THE PACKAGE

• Sleepy Sounds Baby Bear™
• Quick Start Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for  your child’s safety. Do not use the carry handle inside the bear to hang over cribs or playpens.
NOTE
Please save this Instruction Manual as it contains important information.

GETTING STARTED

Battery Removal and Installation

1. Make sure the unit is turned Off.

2. Find the battery cover located on the back of the unit, use a screwdriver to loosen the screw, then open the battery cover.

3. Remove old batteries by pulling up on one end of each battery.

4. Install 2 new AAA batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable
   batteries are recommended.)

5. Replace the battery cover and tighten the screw to secure.

WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES

• Remove rechargeable batteries (if removable) from toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

PRODUCT FEATURES

1. On/Off/Mode Selector
   To turn the unit On, slide the On/Off/Mode Selector to Hug Me mode or Sleep mode position. You will hear sweet songs, tender phrases and soothing sounds in Hug  Me mode and soothing songs and melodies in Sleep mode. To turn the unit Off, slide the On/Off/Mode Selector to the Off position.

2. Detachable Night-Light
   The Detachable Night-Light creates a gentle glow in the nursery or on the go. Remove the night-light from the bear and pop the bear in the washing machine to clean.

3. Automatic Shut-Off
   To preserve battery life, the Sleepy Sounds Baby Bear™ will automatically shut off after approximately 60 seconds without input in Hug Me mode. The unit can be  turned on again by pressing the Heart Button.

NOTE
If the unit powers down or if the light fades out during play, please install a new set of batteries.

ACTIVITIES

1. Sleep Mode
   Press the light-up Heart Button to hear soft sounds, short tunes and soothing melodies. The lights fade in and fade out with the sounds. In Sleep mode it will activate 15  minutes of soothing melodies and nature sounds to ease baby back to sleep.

2. Hug Mode
   Press the Heart Button in Hug mode to hear loving phrases and sing-along songs. Little ones will love to cuddle the bear and feel comforted. The lights fade in and out  with the sounds.

MELODIES

SONG LYRICS

Song 1
It’s time to go to sleep,
No time for even a peep.
The night’s begun,
The stars are out,
It’s time to go to sleep.
Song 2
Hush little baby,
Please close your eyes.
You’ll feel safe if you hold me tight.
Song 3
Rock a bye, baby, time to sleep,
Dreaming of what tomorrow will bring.

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.

IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com  and filling out our Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information,  which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to  contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide  reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and  used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a  particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the  user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name: VTech®
Model: 5398
Product Name:
Sleepy Sounds Baby Bear™
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE  MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING  INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty

TM & © 2022 VTech Holdings Limited.
All rights reserved.
IM-539800-000
Version:0

References

• Best Kids Tech Toys | Electronic Learning Toys | VTech America

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>