Avant GS 1300 Front Fender Extension Installation Guide

: August 31, 2024
: AVANT

Table of Contents

Avant GS 1300 Front Fender Extension
Product Information
Product Usage Instructions
PARTS
INSTALLATION
Care Instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Avant GS 1300 Front Fender Extension

Product Information

Specifications

Product Name: Avant GS 1300 Front Fender Extension
Compatibility: Fits 2024+ BMW R1300 GS
Tool Required: Torx T25 Screwdriver
Parts Included: 1 Avant, 1 Sheet Protection Film, 2 Avant Brackets, 10mm T25 Torx Screws

Product Usage Instructions

Place the bike on its center stand on level ground. Turn the handlebars for installation convenience. Clean the top side of your front fender.
Apply the Protection Film to the bottom of the front fender aligning its edges to the fender. The film can be repositioned if needed.
Slip the Avant over the front fender until the tip of the fender fits snuggly into the receiving shoe. Ensure the sides fit up against the fender’s side edges.

FAQ

Q: Can I reposition the Protection Film once applied?
A: Yes, the Protection Film can be repositioned if needed by lifting and re- applying it to best align with the Avant.
Q: How often should I check the screw tightness after installation?
A: It is recommended to re-check screw tightness after the first ride and periodically thereafter to ensure secure assembly.

PARTS

1 Avant
1 Sheet Protection Film
2 Avant Brackets + 10mm T25 Torx Screws

Tool Required: Torx T25 Screwdriver

INSTALLATION

PLACE THE BIKE ON ITS CENTER STAND ON LEVEL GROUND.
Turn the handlebars for installation convenience. Clean the top side of your front fender.

Avant features two threaded mounting brackets to ensure tight assembly with the fender.
Apply the Protection Film to the bottom of the front fender aligning its edges to the fender. The film can be repositioned, if needed, by lifting and re-applying it to best align with the Avant.
Slip the Avant over the front fender until the tip of the fender fits snuggly into the receiving shoe. Make sure the sides fit up against the fender’s side edges
Position a mounting bracket with your fingers behind the mounting flange in between the raised ribs. The bracket-gripping edge faces the inside of the fender.
Pre-tighten the screw with a T-25 Torx driver. Install the opposite side bracket in the same way. Check final alignment and tighten both screws securely.
Re-check screw tightness after the first ride, and periodically there after.

WARNING AND DISCLAIMER: All parts manufactured, designed or sold by MachineartMoto (“MaMo”) should be installed by a qualified motorcycle technician. The risk of injury is increased by improper installation or misuse of equipment. MaMo’s customers must exercise good judgment in the use, control, alteration, part selection and installation, and maintenance of their motorcycles.