Mau Vista Wall Cat Perch Instruction Manual
- August 31, 2024
- Mau
Table of Contents
Mau Vista Wall Cat Perch
Product Information
Specifications
- Label: A
- Included Parts:
Shape| Description| Quantity
---|---|---
A| Base| 1
B| Platform| 1
C| Anchor| 2
D| M5 x 50mm Bolt| 2
E| M6 x 60mm Bolt| 3
F| Leveler| 1 - Required Tools (Not Included):
- G – Measuring Tape (1)
- H – Screw Driver (1)
- I – Power Drill (1)
- J – 5/8 Drillbit (1)
Product Usage Instructions
Assembly Steps:
- Attach the Base (A) to the Platform (B) using the provided M5 x 50mm Bolts (D).
- Secure the Anchor (C) to the assembled Base and Platform structure.
- Use the M6 x 60mm Bolts (E) to attach the Leveler (F) to the Base.
Installation Guidelines:
Ensure all components are securely fastened using the appropriate tools listed
in the manual.
Frequently Asked Questions (FAQ)
-
Q: Can I use a different size of bolts for assembly?
A: It is recommended to use the specified bolt sizes for optimal performance and safety. -
Q: Do I need to follow a specific order during assembly?
A: Yes, it is advised to follow the assembly steps provided in the manual to ensure proper installation.
Scan the QR code to view the assembly video or go to maupets.com/pages/assembly
INCLUDED PARTS
REQUIRED TOOLS (NOT INCLUDED)
QUESTIONS?
Contact support at info@maupets.com
ASSEMBLY INSTRUCTION
STEP 1
Begin by placing the base (A) against the wall. Use the leveler (F) to make
sure the base (A) is completely flat and horizontal. Grab your pencil and
carefully mark the two top holes on the base that are colored red (view image
below). These are the spots you’ll drill into for wall mounting.
IMPORTANT: Don’t mark the blue dots – those are where the platforms (B)
will connect later.
STEP 2
With a power drill (1), use the 5/8″ drillbit (J) and drill holes into the two
red marks you made in step 1. These holes will secure the base to the wall.
STEP 3
Take your 3 bolts (E) and push them through the flat back of the base, not the
indented side. Make sure the bolts line up perfectly with the 3 slots on the
back platform (B). Once aligned, use the screw driver (H) to screw the bolts
(E) to securely attach the back platform (B) to the base (A). Remember, the
bottom of the platform (B) should face the bottom of the base (A).
STEP 4
Use the remaining bolts (D) and insert them through the 2 top holes (marked
with red) located on the front of the base (A). On the other side of the base
(A), screw the anchors (C) onto the tips of these bolts (D).
IMPORTANT: Make sure the anchors (C) stay at the very ends of the bolts
(D).
STEP 5
Push the anchors (C) into the drilled holes in the wall (figure 1). To secure
the base to the wall, pull the bolt (D) back slightly to engage the anchor (C)
in the wall (figure 2). Then, start screwing the bolt (D) by hand while
continuously pulling it back a little bit. Once you’ve achieved a snug hand-
tight fit (figure 3), use a screwdriver (H) to fully tighten the bolt (D) and
secure the base (A) firmly to the wall.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>