AiFuke W08 Aluminum Alloy 3 in 1 Magnetic Holder and Wireless Charger User Manual
- August 28, 2024
- AiFuke
Table of Contents
W08
ALUMINUM ALLOY 3-IN-1 MAGNETIC HOLDER &
WIRELESS CHARGER (UPGRADE-FREE) Instructions
Product Introduction
This product is a three-in-one fast wireless charger, Which can wirelessly
charge mobile phones/Watch/TWS bluetooth headsets that support the oi standard
at the same time. It is a convenient and practical intelligent electronic
device.
Wirelessly charge your device by placing it in the charging area, And you can
video chat or watch your favorite movies while charging.
It is recommended to use a power adapter of 20W and above.
Specifications
Name| W08 Aluminum alloy 3-in-1 Magnetic Holder & Wireless Charger (Upgrade-
free)
---|---
Model| Wireless Fast Charging
Material| Aluminum Alloy
Technology| TYPE-C
Input| 9V – 2. 5A; 22 W (Max)
Output| 15W+3W+2.5W
Net Weight| 195.3g
SIZE| 13367120mm
Operation Steps
- Connect the charging cable to this product before charging other devices.
- Piace your phone/ Watch/TWS earbuds on the wireless charging area and it will start charging after 0.1S. Remove your device when it is fully charged or amid the process ifneeded.
Cautions
- Do not soak the product in water to avoid short circuit.
- Do not disassemble or hit the product to avoid damage.
- Do not place the product near flammable and explosive liquids, gas or other items.
- Do not place the product near magnetic card, magnetic objects or precision machines.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>