Shenzhen Hanker Technology SK100 Computer Soundbar User Manual
- June 5, 2024
- Shenzhen Hanker Technology
Table of Contents
Shenzhen Hanker Technology SK100 Computer Soundbar User Manual
Package Included
Specification
Product Diagram
Button Control
Use Your Soundbar
The soundbar does not have a built-in battery, please insert the USB plug into the USB port on the desktop, laptop, tablet, power bank, etc.
- Wired mode: the soundbar defaults to this mode when it is turned on.
- When the Bluetooth Indicator light is off, it means the wired mode is on.
- Insert the 3.5mm Audio Cable into the “AUX IN” jack at the back of the soundbar and plug the other end into your device.
Note:
- When want to use wired mode, please make sure the soundbar is not in Bluetooth mode.
- Quickly press the volume knob twice to switch from Bluetooth mode to wired mode.
Wireless connection via Bluetooth
-
Switch to Bluetooth mode
-
Pair with your device
Once connected, a beep will be heard and the Bluetooth indicator (blue) will flash every 5 seconds.
Note:
- Make sure the soundbar isn’t connected to other devices, otherwise please disconnect this device.
- If you can’t find other connected devices, please press and hold the knob for 3 seconds to return to the Bluetooth pairing mode (Bluetooth Indicator flashes blue/white).
- Keep the soundbar and your device within 16ft/5m.
Attention
Troubleshooting of Sound
If there is no sound comes out from the soundbar, please try the following
operations:
▶ Rotate the volume knob clockwise to raise the volume of the soundbar.
▶ Adjust the volume on your device.
▶ Press the volume knob to resume in case the soundbar paused.
▶ Re-insert the USB plug
Troubleshooting of Bluetooth Connection
▶ Make sure that the soundbar Bluetooth paring mode is on(Bluetooth Indicator
flashes blue/white).
▶ Make sure the Bluetooth of the soundbar is not connected by other devices.
▶ Unplug the 3.5mm Audio Cable from your device.
▶ Delete “SK100” memorized on your device, then search for “SK100” and connect
again.
Worry-free Service Guarantee
- 30 days free return and exchange.
- 18 months warranty.
- Lifetime friendly customer service.
Please contact us for more details and further instructions via
support@nylavee.net
Extend 2-years warranty: www.nylavee.net
FCC Compliance This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must withstand any
interference received, including interference that may cause undesired
operation.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.
Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>