homyl MIC-S114 12W Bluetooth Speaker LED Bulb User Manual
- June 10, 2024
- homyl
Table of Contents
MIC-S114 12W Bluetooth Speaker LED Bulb
User Manual
MIC-S114 12W Bluetooth Speaker LED Bulb
Product Parameters
Voltage:100‐240V/ 50‐60Hz
Power:3W
LED power:1.5W
RGB power:1.5W
Speaker power:3W
Frequency response:135Hz ‐15KHz
Wireless version:4.2
Support configuration:A2DP
Radio range:10m(33ft)
LED light color: White or warm white
The steps to use this led music bulb
- Applicd this bulb to the E27(B22)basic, and then power the bulb.
- The bulb is lit up. then you can use the remote control to adjust the light color.
- Turn on your Bluetooth device (your phone ).search and connect to the bulb.
- Connected successfully. now you can play the music you like with the bulb.
Product Notes:
- please confirm the voltage first.
- please check the specifications of the product carefully before ordering to insure a proper fit.
- Do not disassemble any bulbs by yourself.
- Be sure to cut the power off before beginning installation to avoid personal injury.
- The bulb can be turned off by the remote control. and you can still use the it as a speaker
- One remote controller can control multi bulbs(the light).but one bulb can only be connected to one Bluetooth device (output sound).
Application
Suitable for the
bedroom.closet,cabinet.corridor,workshop,basement,garage,stairwell,oil
depots, roof, door and other places.
Package Includes:
1X 12W Bluetooth speaker LED bulb
1 X User manual
1 X Remote controller(Battery is included)
NOTE:PLEASE DON’T INSTALL THE BULBS IN HUMID ENVIRONMENT!
Warning: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
‐‐Reorient or relocate the receiving antenna.
‐‐Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different.
from that to which the receiver is connected.
‐‐Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device and its antenna(s) must not be co‐located or operation in
conjunction with any other antenna or transmitter
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This
equipment should be installed and operated with minimum distance of
20cm the radiator your body. This device and its antenna(s) must
not be co‐located or operation in conjunction with any other antenna
or transmitter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>