DMOS Universal Mount Installation Guide
- August 27, 2024
- DMOS
Table of Contents
DMOS Universal Mount
INSTRUCTIONS
Works with any long-handled tool or axe with a handle diameter of 1 – 2″
CONTENTS
The mount comes with:
- 4 each of .25”-20 x 1.75” hex bolts
- 8 each of .25” flat washers
- 4 each of .25”-20 nylon locking hex nuts
- 2 – 5.25” x 1.25” backing plates
INSTALLATION
- Loosen knob and swing clamp away from DMOS logo.
- Remove cork shipping pads before use. Raise lid.
- Place your mount on your roof rack, metal MOLLE panel, or spare tire mount.
- Using the pre-drilled slots on the mount, determine attachment points on any bar or rack up to 2” diameter.
- Insert a hex bolt and flat washer through selected pre-drilled slot, then through the rack. Secure mount with backing plate (if using), flat washer and locking hex hut. Leave locking hex nuts loose until all bolts are positioned.
- Repeat with remaining hex bolts until mount is in desired position and secured. Fully tighten all locking hex nuts.
SECURING YOUR SHOVEL OR AXE IN THE MOUNT
- Place the shovel or axe handle in the cradle.
- Close the lid and swing the clamp up into the lid slot and tighten the knob to secure.
- For added security, use the padlock tabs with a lock of your choice.
LOVE YOUR DMOS® PRODUCT? DON’T KEEP IT A SECRET – LEAVE A REVIEW!
Customer Support
QUESTIONS?
Hit us up at
info@dmosproshoveltools.com
DMOS® Pro Shovel Tools
Bellingham, WA
dmosproshoveltools.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>