DMOS Delta Shovel and Pro Mount Installation Guide
- August 27, 2024
- DMOS
Table of Contents
DMOS Delta Shovel and Pro Mount
CONTENTS
The mount comes with:
- 4 each of .25”-20 x 2.75” hex bolts
- 8 each of .25” flat washers
- 4 each of .25”-20 nylon locking hex nuts
- 2 – 11” x 2” backing plates
- 1 linchpin
INSTALLATION
- Place your mount on your roof rack, metal MOLLE panel, or spare tire mount.
- Using the pre-drilled slots on the mount, determine attachment points on any bar or rack up to 2” diameter.
- Insert a hex bolt and flat washer through selected pre-drilled slot, then through the rack. Secure mount with backing plate (if using), flat washer and locking hex hut. Leave locking hex nuts loose until all bolts are positioned.
- Repeat with remaining hex bolts until mount is in desired position and secured. Fully tighten all locking hex nuts.
SECURING YOUR DELTA SHOVEL IN THE MOUNT
- Collapse your Delta Shovel into stow mode (see DMOS Delta Shovel® instructions).
- Place the shovel connector over the connector bridge.
- Using the shovel handle, slide the shovel to the end of the mount, then press shovel shaft into shaft clip until it snaps into place.
- Close the mount door and secure the mount latch with the enclosed linchpin.
- For added security, use the padlock tabs with a lock of your choice.
LOVE YOUR DMOS® PRODUCT? DON’T KEEP IT A SECRET – LEAVE A REVIEW!
Customer Support
QUESTIONS?
Patent: dmosproshoveltools.com
Hit us up at info@dmosproshoveltools.com
DMOS® Pro Shovel Tools
Bellingham, WA
dmosproshoveltools.com
References
Read User Manual Online (PDF format)
Loading......