Aoxingao PC063N Bluetooth Beacon Instructions
- August 26, 2024
- Aoxingao
Table of Contents
PC063N Instruction manual
PC063N Bluetooth Beacon
This product is a BLUETOOTH Beacon.
This product use 3.0V coin cell battery for power supply.
The products work in the 2.4GHz worldwide lsM band, and theTransmit/Receive
operating frequency is from 2400MHz~2480MHz. This BLUETOOTH beacon support
Bluetooth version V4.0. Bluetooth V4.0 BLE:
Instructions for use:
Use a small magnet to approach the sensing button on the right-hand side of
the product, and the device will flash a green light to remind when turned
on,then iBeacon begin broadcasting the name and RSSI by Bluetooth
We will receive the broadcasting name and signal by phone Bluetooth
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modi fi cations to this device not explicitly approved
by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
FCC-ID:2ACN3-PC063N
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>