LAUNCH LS4-NISN-01 Universal Remote Key User Manual
- August 20, 2024
- Launch
Table of Contents
LAUNCH LS4-NISN-01 Universal Remote Key
Product Information
Specifications:
- Model: LS4-NISN-01
- Battery Type: 2032, 3V
- Frequency Band: RFID (433.92 MHz)
- Maximum Frequency Power: -27.76 dBm
Product Usage Instructions
Changing Battery:
- Press the backside button to release the mechanical key holder.
- Use a tool to separate the shell.
- Remove the old battery and replace it with a new 2032 3V battery. Ensure correct polarity.
- Reassemble the key as before.
Pairing Method:
To pair with your vehicle, refer to the specific instructions provided for your vehicle model.
Frequently Asked Questions (FAQ)
-
Q: How do I pair the universal remote key with my vehicle?
A: Refer to the pairing method section in the user manual for instructions specific to your vehicle model. -
Q: What type of battery does the remote key use?
A: The remote key uses a CR2032 3V battery. Follow the steps in the manual to replace the battery when needed. -
Q: What is the frequency band of operation for this device?
A: The device operates on the RFID frequency band at 433.92 MHz.
Overview
LS4-NISN-01 Universal Remote Key is suitable for vehicle which contains the
LAUNCH receiver.
Note : The operating temperature of the product is -20–50℃.
Button Description
| 1 | Lock button |
|---|---|
| 2 | Unlock button |
| 3 | Trunk button |
| 4 | Panic button |
Change Battery
First use or when the battery runs out need to change new battery, following steps:
-
Press the back side button for loose the mechanical key holder
-
Use the tool into the gap to separate the shell
-
Take the battery out and replace new one
Note : The battery type is 2032 with 3V, ensure the positive and negative of the battery is correct -
Install the key same as before
Pairing method
- Pairing with vehicle: Referring to the corresponding vehicle models to match
FCC statements
15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
15.105 Information to the user.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
CE statements
Frequency Band(s)
This device operates with the following frequency bands and maximum frequency
power.
Note : The product is compliant with these power limits required by the
European Union. Frequency bands supported by the product vary by model.
RFID (433.92 MHz) Max Pe.r.p. is -27.76 dBm.
EU DECLARATION OF CONFORMITY
Hereby, Launch Tech Co.,Ltd. declare that this product with model LS4NI01
complies with Directive 2014/53/EU and 2011/65/EU.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>