TAC 3S-C124T 3 Oval Bent End Sidebars Installation Guide
- August 19, 2024
- TAC
Table of Contents
TAC 3S-C124T 3 Oval Bent End Sidebars
PARTS LIST
| 1 | Driver/Left Sidebar | 1 | Passenger/Right Rear Mounting Bracket |
|---|---|---|---|
| 1 | Passenger/Right Sidebar | 4 | 1/2” x 2” Hex Bolts |
| 1 | Driver/Left Front Mounting Bracket | 4 | 1/2” Lock Washers |
| 1 | Passenger/Right Front Mounting Bracket | 4 | 1/2” x 1-1/2” OD x 1/8” Flat |
Washers
1| Driver/Left Rear Mounting Bracket| 4| 12mm x 24mm OD x 2.5mm Large Flat
Washers
PROCEDURE
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
- Start the installation under the Passenger/Right side of the vehicle. Locate the front body mount, (Figure 1). Remove the front body bolt.
- Select the Passenger/Right Front Mounting Bracket.
- For 2019 models: Reuse the factory body bolt to attach the Bracket to the body mount, (Figures 2 & 3). Do not tighten hardware at this time.
- For 2020 models: Reuse the factory body bolt and (1) 12mm Large Flat Washer to attach the Bracket to the body mount, (Figures 2 & 3). Do not tighten hardware at this time.
- Move to the rear mounting location, (Figure 4). Repeat Steps 1 & 2 to attach the Passenger/Right Rear Mounting Bracket to the rear body mount, (Figures 5 & 6).
- Carefully unwrap and select the Passenger/Right Sidebar. Use the illustration above to help identify the correct Sidebar. Attach front of the Sidebar to the bracket with (1) 1/2” Hex Bolt, (1) 1/2” Lock Washer and (1) 1/2” Flat Washer, (Figures 7 & 8). Do not tighten hardware.
- Repeat Step 4 to attach the rear of the Sidebar to the Rear Bracket, (Figures 9 & 10). Do not tighten hardware at this time.
- Level and adjust the Sidebar as necessary and fully tighten all hardware.
- Repeat Steps 1—6 for Driver/Left Sidebar installation
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Sidebar.
FAQ
Frequently Asked Questions
- Q: Do I need special tools for installation?
- A: Basic hand tools should be sufficient for the installation process. Assistance is recommended for handling larger parts.
- Q: Can I install these sidebars on my own?
- A: While it is possible to install the sidebars on your own, having assistance can make the process smoother and more efficient.
- Q: How often should I wax the product?
- A: Regular waxing is recommended to maintain the finish and provide additional protection. The frequency of waxing can vary based on usage and environmental conditions.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>