LUXRITE LR25475,LR25480 2 Inch Trimless Recessed Downlight Instruction Manual
- August 17, 2024
- LUXRITE
Table of Contents
LUXRITE LR25475,LR25480 2 Inch Trimless Recessed Downlight
Introduction
IMPORTANT
READ ALL INSTRUCTIONS BEFORE INSTALLING FIXTURES. KEEP FOR FUTURE REFERENCE.
SAFETY: FOR YOUR SAFETY, THIS FIXTURE MUST BE WIRED IN ACCORDANCE TO
LOCAL ELECTRICAL CODES AND ORDINANCES. ALL WORK SHOULD BE DONE BY A QUALIFIED
ELECTRICIAN.
WARNING: MAKE SURE POWER IS OFF FROM THE ELECTRICAL PANEL BEFORE STARTING
INSTALLATION OR ATTEMPTING ANY MAINTENANCE. INDOOR INSTALLATION ONLY.
TOOLS REQUIRED
- SAW, MEASURING TAPE, ELECTRICAL WIRING (USE TAPE AND GAUGE SUITABLE FOR APPLICATION TO CONNECT THE FIXTURES.
PRE-INSTALLATION
- Turn the power OFF from the electrical panel before starting installation.
- Locate a suitable position to place the fixture and open it by the cut-hole dimensions (refer to Hole Cut Table for appropriate size)
- Run electrical wire from the switch (power supply) through the mounting hole -use NMD90 Romex or BX cable.
- Align the inside edge of the Zer Clearance plaster frame to the drywall hole and screw it in place. (Fig. 1)
- Plaster over the plaster frame, be careful not to fill past the raised rim. (Fig. 2)
DRIVER WIRING
-
Open the hardwire box swing cover and remove the appropriate knockout(s).
-
Insert the electrical supply cable through the knockout and secure it with a cable connector (sold separately).
-
Using wire nuts, connect the green ground wire of the cable to the green wire on the box.
Connect the black wire of the cable to the black wire of the box. (Fig. 3) -
Place all wiring and connections back into the box and close the cover.
-
Insert the hardwire box through the mounting hole. (Fig. 4)
NEW CONSTRUCTION APPLICATIONS : The Hardwire box shall be firmly secured
to studs, joists, or similar fixed structural units.
REMODEL APPLICATIONS: Do not require the hardwire box to be firmly
secured after the mounting plates, studs, joists, or structural units have
been concealed.
FIXTURE INSTALLATION
- Select Reflector and Trim and push onto the module (Fig. 3)
- Connect the fixture to the hardwire box by inserting and twisting the male/female connectors and use a switch to select Color Temperature. (Fig. 4)
- Push spring-loaded clips on the fixture upwards and insert the fixture base into the mounting hole. Release the clips and the fixture will be pulled flush to the ceiling. (Fig. 5)
- Once assembly is complete, turn on the power to confirm the fixture is working properly.
Dimension
CONTACT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>