LIVARNO home IAN 446451 Paddling Pool Xxl Instruction Manual
- August 15, 2024
- LIVARNO home
Table of Contents
LIVARNO home IAN 446451 Paddling Pool Xxl
List of pictograms used
Safety information
Instructions for use
Note
XXL Paddling Pool
Introduction
We congratulate you on the purchase of your new product. You have chosen a
high quality product.
Familiarise yourself with the product before using it for the first time. In
addition, please carefully refer to the operating instructions and the safety
advice below. Only use the product as instructed and only for the indicated
field of application. Keep these instructions in a safe place. If you pass the
product on to anyone else, please ensure that you also pass on all the
documentation with it.
Intended use
This article is intended for use for playing/paddling.
This product is intended for private, outdoor use only.
The product is not intended for commercial use. The product is suitable for
children for 5 years or above.
Description of parts and features
- End cap
- Valve opening
- Stopper
- Patches for repairs
Technical data
Dimensions: HG09935:
approx. 305 x 183 x 60cm
(when inflated)
Weight: approx. 6150g
Fill capacity: approx. 1160L
Contents
- 1 paddling pool
- 3 interlocking quick-release valve
- 2 patches for repairs
- 1 instruction manual
Safety advice
PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE!
Avoid the risk of injury!
RISK OF LOSS OF LIFE OR ACCIDENT TO INFANTS AND CHILDREN!
Never leave children unsupervised with the packaging material or the product. The packaging material presents a suffocation hazard and there is a risk of loss of life from strangulation and/or drowning. Children often underestimate danger. Always keep the product out of reach of children.
-
WARNING! Never leave your child unattended – drowning hazard.
-
WARNING! Only for domestic use.
-
WARNING! Wear personal flotation devices.
-
WARNING ! Do not place on an incline.
-
Please read carefully and retain for future reference.
-
Children can drown in very small amounts of water. Empty the pool when not in use.
-
Do not install the paddling pool over concrete, asphalt or any other hard surface.
-
When filling with water, the maximum depth of the water should not exceed the maximum water level mark on the product (see fig. D).
-
Once inflated, make sure that the product does not come in contact with stones, gravel or other sharp objects which could puncture the item.
Non swimmers safety
- Continuous, active, and vigilant supervision of weak swimmers and non-swimmers by a competent adult is required at all times.
- Designate a competent adult to supervise the pool each time it is being used.
- Weak swimmers or non-swimmers should wear personal protection equipment when using the pool.
- When the mini-pool is not in use, remove all toys and appealing objects from the water and the coping to avoid attracting children to the pool.
- When the pool is not in use, remove all toys or other objects from its surrounding that could be used by a child as a device to facilitate the access into the mini-pool (e.g. chairs, big toys, etc.).
Safety devices
- It is recommended to install a barrier (and secure all doors and windows, where applicable) to prevent unauthorized access to the pool.
- Personal protective equipment, barriers, pool covers, pool alarms, or similar safety devices are helpful aids, but they are not substitutes for continuous and competent adult supervision.
Safety equipment
- It is recommended to keep rescue equipment (e.g lifebelt) close to the pool.
- Keep a working phone and a list of emergency phone numbers near the pool.
Safe use of the mini-pool
- Encourage all users especially children to learn how to swim.
- Learn Basic Life Support (Cardiopulmonary Resuscitation – CPR) and refresh this knowledge regularly. This can make a life-saving difference in the event of an emergency.
- Instruct all pool users, including children, what to do in case of an emergency.
- Never dive into shallow water. This can lead to serious injury or death.
- Do not use the pool when using alcohol or medication that may impair your ability to safely use the mini-pool.
- When pool covers are used, remove them completely from the water surface before entering the pool.
- Replace water regularly according to manufacturer recommendations and, depending on hygienic conditions, its cleanliness, its clarity, and its odour, or if any debris or stains are present in the pool. Use of chemicals in mini-pools without water circulation may result in direct contact with the chemicals or in areas of high chemical concentration resulting in injury to the users.
- If chemicals are occasionally used to reduce the frequency of water replacement, follow chemicals manufacturer instructions closely (especially never use more than recommended), ensure the appropriate mixing of chemicals to avoid possible personal injuries and store chemicals out of reach of children.
- The use and installation of any electrical appliances around pools shall be in accordance with the national regulations.
- Where applicable, remove any means of access from the mini-pool and store it out of reach of children whenever the pool is not in use.
- Use of accessories not approved by the pool manufacturer (e.g. ladders, covers, pumps, etc.) may result in risks of injuries or property damages
Operation
Note: Before using the product for the first time, check it carefully for
holes, porous places and seams that are not airtight.
Recommendation: An adult should always assemble the product. Please
follow the individual assembly steps in the order indicated.
Recommendation: Choose a suitable flat and clean surface with plenty of
space to unpack and unfold the product. Spread the product out in the place
where it will later be used.
Recommendation: Pump the product up and leave it alone for one day. Let a
new product air outside in fresh air for a couple of days.
Recommendation: Place the mini-pool on a level surface at least 2 m from
any structure or obstruction such as a fence, garage, house, overhanging
branches, laundry lines or electrical wires.
Pumping up the product
CAUTION! Inflatable plastic products react sensitively to the cold and hot.
That is why you should never use the product when the ambient temperature
falls to below 15°C and rises above 40°C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible for pumping the pool
up. Make sure that you do not pump too much air into the product. On no
account should you use a compressor. Stop the process when resistance
increases during pumping and the seams start to stretch. Otherwise the
material might tear. Only use manual pumps and/or pumps specifically designed
for use with inflatable plastic products.
-
Roll the product out first and then check for holes, tears and other damage (see Fig. A).
Note: Use a pump with conical adapter with a diameter of approx. 17.8mm for the valve opening 2 . -
Take the end cap
**1**off the stopper**3**in order to open it. -
Pump the product up
IMPORTANT! Keep in mind that air temperature and weather conditions can
affect the air pressure inside inflatable products. In cold weather the
product behaves as if it has less air pressure in it because the air inside
contracts. Under these conditions you may have to add air. In hot weather the
air inside expands. Under these conditions you may have to remove air in order
to avoid overfilling.
Place the end cap **1** onto the stopper **3** in order to close it.
Deflating the product
- Pull the stopper 3 off the valve opening
2in order to open it. - Allow the air to escape completely.
- Slowly fold the product together **(see Fig. A)
**
Note : Make sure that the product is completely dry before folding it together
Cleaning and Maintenance
- On no account should you use corrosive or scouring detergents.
- Use a slightly damp, lint-free cloth to clean the product.
Change the water of paddling pools frequently (particularly in hot weather) or when noticeably contaminated.
Repairing the product
Note: Minor damage can be repaired by the owner using the supplied repair
kit. Have any major damage carried out at a specialist repair shop.
First let all the air escape from of the product.
Cut the patch **4** to suit the size of the hole.
Note: Ensure that the patch **4** is larger than the hole and overlaps
the edges of the hole. Round off the sides of the patch **4** and pull off
the protective foil.
Place the patch **4** on the hole and press it down firmly. If necessary,
stand a heavy object on the patch **4** .
Wait for 24 hours before you pump up the product again.
Storage instruction
Make sure that the product is completely dry both inside and out when wishing to store it for any length of time. Otherwise mildew and mould may form.
Store the product in a dark, dry place–out of reach of children.
The ideal storage temperature is 10–20°C.
Ensure that the product does not come into contact with sharp objects during
storage.
Disposal
The packaging is made entirely of recyclable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more details of how to
dispose of your worn-out product.
The product incl. accessories and packaging materials are recyclable and are
subject to extended
producer responsibility. Dispose them separately, following the illustrated
Info-tri (sorting information), for better waste treatment. The Triman logo is
valid in France only.
Warranty
The product has been manufactured to strict quality guidelines and
meticulously examined before delivery. In the event of material or
manufacturing defects you have legal rights against the retailer of this
product. Your legal rights are not limited in any way by our warranty detailed
below.
The warranty for this product is 3 years from the date of purchase. The
warranty period begins on the date of purchase. Keep the original sales
receipt in a safe location as this document is required as proof of purchase.
Any damage or defects already present at the time of purchase must be reported
without delay after unpacking the product.
Should the product show any fault in materials or manufacture within 3 years
from the date of purchase, we will repair or replace it – at our choice – free
of charge to you. The warranty period is not extended as a result of a claim
being granted. This also applies to replaced and repaired parts.
This warranty becomes void if the product has been damaged, or used or
maintained improperly.
The warranty covers material or manufacturing defects. This warranty does not
cover product parts subject to normal wear and tear, thus considered
consumables (e.g. batteries, rechargeable batteries, tubes, cartridges), nor
damage to fragile parts, e.g. switches or glass parts.
OWIM GmbH & Co. KG
Stiftsbergstraße 1
74167 Neckarsulm
GERMANY
Model-No.: HG09935
Version: 01/2024
Last Information Update