EnVisinLED SL-PNL-4R-9W-5CCT-12V J Box Round Panel Downlight Installation Guide
- August 14, 2024
- EnVisinLED
Table of Contents
EnVisinLED SL-PNL-4R-9W-5CCT-12V J Box Round Panel Downlight
IMPORTANT:
Read all instructions before installing fixtures. Retain for future reference.
- To be used only with listed class 2 power supplies
- Always consider voltage drop effect when linking fixtures together.
- To extend drive life span, do not exceed 80% of driver rated load.
SAFETY:
For your safety, this fixture must be wired in accordance to local electrical codes and ordinances. All work should be done by a qualified electrician.
WARNING:
Make certain power is OFF from the electrical panel before starting installation or attempting any maintenance. Indoor installation only.
1-PACK INCLUDED COMPONENTS:
- 1 X LED snap trim adjustable downlight
TOOLS REQUIRED:
- Power drill
- Screwdriver
CUT HOLE SIZE:
- 1-1/4
ASSEMBLY INSTRUCTIONS:
- Open packaging and place all components onto a clean surface.
- Turn power OFF from the electrical panel before starting installation.
RECESSED MOUNTING:
With a screwdriver (supplied by others) detach the torsion clips from the LED light. In your desired area drill a 1-1/4” hole, using a cut hole saw (suppled by others). Run the wires through the cut hole, then secure the LED puck light to medium with screws provided (Fig.2). Connect the trim ring back to the LED light magnetic tag.
HARDWIRE:
Use wire type and gauge suitable for application to connect the fixtures and twist-on wire connectors (suppled by others) (Fig. 3) Ensure correct polarity is followed through the line (Fig. 1)
- Place the driver to the desired secured location
- Once assembly is complete, turn on the power to confirm fixture is working properly
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>