ARIZE AWD310 Water Detector User Manual
- August 9, 2024
- ARIZE
Table of Contents
ARIZE AWD310 Water Detector
Product Description
Pairing Setting
- Power on the product.
- Press the reset button for 5 seconds and release, the green LED will flash for pairing setting.
Pairing Setting:
- Press the reset button more than 5 seconds, the green LED is on, the green LED flashes, means ready for pairing setting. It keeps on flashing for 20s during pairing setting.
- The green LED will be on for 5s to indicate pairing setting succeeds. If fails, red LED will be on 5s then off.
Installation Instructions
Place the product in the detection area.
Technical Parameters
Toxic or Hazardous Substances or Elements of this Product
Warranty
What is not covered under this warranty:
- The product owner has no warranty certificate or the warranty service has expired.
- Damage caused by improper use, maintenance, or storage.
- Damage caused by disassembly and repair without our authorization.
- Damage caused by force majeure.
- Normal discoloration and depreciation after the product has been used.
FCC STATEMENT
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
FCC SDOC SUPPLIER’S DECLARATION OF CONFORMITY
Arize Corporation hereby declares that this equipment complies with the FCC
rules. The declaration of conformity may be consulted in the support section
of our Website, accessible from www.arizehub.com.
Vendor Form
User information (Specify real information. We promises to use the information
only for after-sales services.)
