Trudoor VE006-L Lever Blank Escutcheon Lever Trim Installation Guide

Trudoor VE006-L Lever Blank Escutcheon Lever Trim

Product Specifications:

• Latch x1
• Latch & Strike screws x4
• Strike x1
• Mounting Dust Cover Screw x2 x1 (optional)
• Rear Lever x1
• Front Lever x1
• Door thickness: 1-3/8 to 2 (35mm to 50mm)
• Backset options: 2-3/8” (60mm) or 2-3/4” (70mm)
• Depth required: 1/2″ (12.7mm)

Product Usage Instructions

• Prepare the Door and Check Dimensions:
  Make sure the hole in the door frame is drilled a minimum of 1/2” (12.7mm) deep to accommodate the latch when the door is closed.

• Latch Backset Adjustment:
  Backset is the distance from the door edge to the center of the hole in the door.
  If your door backset is 2-3/8” (60mm), no adjustment is needed. If it is 2-3/4” (70mm), adjust the latch accordingly.

IN-SWING DOOR:

The angle of the latch faces outside.

OUT-SWING DOOR:

The angle of the latch faces inside.

IMPORTANT: The latch should be aligned with the chiseled properly, ensuring the hole in the door frame is drilled a minimum of 1″ (25.4mm) deep.

Test the Lever:

Keep the door open and test both front and rear levers to ensure smooth operation. Rotate the base of the spindle aligning it with the hole.

Frequently Asked Questions

• Q: Can I use an electric screwdriver during installation?
  A: No, it is recommended not to use an electric screwdriver during installation to prevent damage to the product.

• Q: What are the options for backset adjustment?
  A: The latch can be adjusted for either a 2-3/8” (60mm) or 2-3/4” (70mm) backset based on your door requirements.

Thank you for purchasing our products. Please review this manual thoroughly before operating your device. All pictures in this manual are for illustration purpose only. Actual product may vary due to product upgrade

PART LIST

TOOL REQUIRED:

Do not use an electric screwdriver during installation.

INSTRUCTION

INSTALLATION

1. Prepare the door and check dimensions

2. Make sure the hole in the door frame is drilled a minimum of 1/2’’ (12.7mm) deep, to leave enough space for the latch to extend into the door frame when the door is closed.

3. Latch backset adjustment

4. Backset is the distance from the door edge to the center of the hole in the door.

5. The latch is provided with adjustable design which can fit either 2-3/8’’(60mm) or 2-3/4’’(70mm) backset.

6. A. If the backset of your door is 2- 3/8″(60mm), no need to adjust the latch.

7. B. If the backset of your door is 2-3/4″(70mm), please adjust the latch.

8. Install latch and strike
   IMPORTANT:

9. The latch should be aligned with the chiseled properly, make sure the hole in door frame is drilled a minimum of 1″ (25.4mm) deep

10. Install front and rear lever

11. Test the lever

12. Keep the door open, checking out front and rear lever to test if it works smoothly.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>