GoodSleepCO Good Sleep Test User Guide
- August 8, 2024
- GoodSleepCO
Table of Contents
How to use Good Sleep Test – Step by Step
Good Sleep Test
Step 1
→ Unbox the device
Open the box and take out all parts of the device – the Wristband, Sensor &
Wristband Charger.
Step 2
→ Charge Wristband
Plug the supplied USB charging cable into the Wristband and connect to a power
supply.
The Wristband will show an orange light while charging. Once the light turns
green the device is fully charged and ready to use (approx. 2 hours).
Step 3
→ Pair Wristband
Connect the Wristband to your phone or tablet using Bluetooth.
You will be prompted to do this when starting the test.
Step 4
→ Wear the Wristband
Put the Wristband snugly on either wrist using the strap (firm but not too
tight).
Step 5
→ Fit Sensor to finger
Place the Sensor over the top of your index finger on the same hand as the
Wristband. (Note that the light emitting from the Sensor must be directly
irradiated to the side of your fingernail.
Please remove any nail polish or fake nails from the finger.)
Step 6
→ Attach cable
Attach the Sensor cable to the base of the Wristband.
Step 7
→ Turn on
Turn the device on using the on/off button on the Wristband.
Step 8
→ Initiate test
Open the Good Sleep Test function in your SleepCare App. Initiate your test.
Step 9
→ Sleep
Leave the Good Sleep Test device on for the entire time you’re sleeping. Data
will upload to the SleepCare App while you sleep, so please keep the App open.
Step 10
→ Get results
When you wake, take the Wristband off. Stop the test via the SleepCare App.
Results from your sleep will be uploaded. Your Specialist Sleep Report will be
available via the SleepCare App or via your clinician.
If you would like more information, please contact us:
hello@goodsleepco.health
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>