OLG407 Modulus Single Post Pedestal Table Installation Guide
- August 7, 2024
- OLG
Table of Contents
OLG407 Modulus Single Post Pedestal Table Installation Guide
Modulus Single Post Pedestal Table
COMPONENTS
- Steel Plate x1
- Feet Tube x1
- Large Foot x4
- Cross Collar x1
- Foot Glides x4
- Cross Gasket x1
- Table Top x1
SCREWS
- M5x20mm Self Tapping x4
- M8x16mm x4
- M10x110mm x1
- M8x30mm x3
Modulus Single Post Pedestal Table
-
Slide the 4 large feet into the cross collar. Place the cross gasket on top of the feetand collar, and tighten 4xM5 screws into the cross collar
-
Screw the 4 glides into the base of the large feet, leaving the glides one turn from tight (then they can be adjusted easily if the floor is uneven).
-
Place the feet tube into the cross collar, making sure the notch in the bottom of thetube is in-line with the bump inside the cross collar Fig A. Fully tighten the large M10bolt, spring washer and flat washer through the gasket and collar into the tube.
-
Locate the steel plate on top of the feet tube, and line up the 3 holes. Fully tighten the 3 screws into the tube.
-
With the frame assembled, place it upside down onto the work surface, and measure the top from all sides to make sure it’s centered.
-
Fully tighten the last 4 self tapping screws into the work surface.
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>