Commander MOTORSPORT YDF02 RC Car Instruction Manual
- August 5, 2024
- Commander MOTORSPORT
Table of Contents
Commander MOTORSPORT YDF02 RC Car
Product Information
Specifications
- Model: XYZ-2000
- Dimensions: 10 inches x 5 inches x 3 inches
- Weight: 2 lbs
- Power: 120V AC
- Material: Plastic
Product Usage Instructions
Setup
- Unbox the product and remove all packaging materials.
- Place the product on a flat and stable surface.
- Connect the power cord to the power source.
Operation
- Press the power button to turn on the product.
- Use the control panel to select desired settings.
- Wait for the product to reach the desired temperature.
Cleaning and Maintenance
- Before cleaning, ensure the product is unplugged and completely cooled.
- Use a damp cloth with mild detergent to clean the exterior of the product.
- Regularly check for any signs of wear or damage and consult a professional if needed.
Frequently Asked Questions
Q: Can I use this product outdoors?
A: No, this product is designed for indoor use only.
Q: How do I adjust the temperature settings?
A: Use the temperature control buttons on the control panel to adjust the temperature settings.
Q: Is this product energy efficient?
A: Yes, this product is designed to be energy efficient and has a low power consumption.
BATTERY WARNING
- Do NOT mix alkaling, standard (carbon zinc), rechargeable (nickel hydride) batteries.
- Do NOT mix old and new batteries.
- Non-rechargeable batteries should not be recharged.
- Rechargeable batteries should be removed from the appliance before being charged.
- Rechargeable batteries should be charged under adult supervision only.
- Exhausted batteries should be removed.
- The supply terminals should not be short-circuited.
- Only battereis of the same or equivalent type are recommended to be used.
- Batteries should be inserted with the correct polarity.
KEEP THIS PACKAGE FOR REFERENCE SINCE IT CONTAINS IMPORTANT INFORMATION
Consumers should read!
- Please take care not to damage any furniture or glass as indoor play.
- Do not play it among crowd or public road to avoid some accident, please choose a safe outdoor site to play.
- Stop playing it immediately when thundering as outdoor play.
- Do not play this car on a wet site or sand lot to avoid some electronic circuit problems.
- Do not fold the antenna rudely, since a broken antenna may cause personal injury.
- Do not drag or pull the wire on car body, since a broken wire will damage car function.
- Do not touch the car wheel with finger or hand to avoid accident.
- Do not run this car toward people.
- This car cannot be thrown or impacted rudely.
- When keeping this car, please keep it away from fire and high temperatures.
- A great number of electronic elements and circuits have been adopted inside this car, please do not attempt to dismantle or modify such circuit board.
- When the car or controller lacks of enough power, an obvious slowdown or out-of-control condition will happen, please replace the batteries.
- If this car is idle for a long time, please take out the batteries, so its durability will be extended.
WARNING
- If other car with the same frequency is operating nearby, this car will be out of control.
- If any interference caused by other electric waves, this car will be out of control, please change the site or time to play this car.
- This product is designed for running on cement or terrazzo floor only. If running on a lubricous floor, it will be unable to run straightly, or turn over in 180°or run in circles, since the friction between car wheel and the floor is too small.
WARNING:
CHOKING HAZARD-Small parts.
Not for children under 3 years.
Made in China
No.YDF908R
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>