lexman 84733111 Rechargeable Working Light Instruction Manual
- June 3, 2024
- lexman
Table of Contents
lexman 84733111 Rechargeable Working Light
In the Box
Warning symbols
Please read the following instructions
General Safety Instructions
- To avoid risk of injury, proper supervision is needed when your appliance is used around children.
- Cleaning and maintenance must not be done by children without supervision.
- Read the instructions carefully and tollow them to prevent damage and injury.
- For indoor charging only,
- Dry location charging only.
WARNING:
- To reduce the risk of electric shock, do not put the unit in water or other liquids.
- Do not use the product if it has been subjected to a heavy impact, dropped or otherwise damaged in any way until it has been repaired.
- To avoid electric shocks, remove the USB cable from the power supply before cleaning it.
- The light source of the luminaire is not replaceable, when the light source reaches its end of life, the whole luminaire shall be replaced.
- During first use or following a complete discharge, the charging light indicator can take around ten minutes to switch on following connection.
Environmental protection
- This marking indicates that this product must not be disposed of with other household wastes throughout the EU. Since electric and electronic equipment contain hazardous substances, to prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
- Batteries are built into the device; therefore the device must be disposed of only by a specialist.
- To preserve natural resources, please recycle or dispose of the battery pack properly. This battery pack contains lithium batteries. Consult your local waster authority for information regarding available recycling and/or disposal options. Discharge your battery pack by operating your lamp, then open the battery box of lamp, remove the battery paCk from the lamp and cover the battery pack connections with heavy duty adhesive tape to prevent short Circuit and energy discharge. Do not attempt to open or remove any of the components.
Appliance specifications
TECHNICAL CHARACTERISTICS
Input| 5V DC, 1A| Fully charge time| 3H
Protection level| IP65 without USB cable.P20 with USB cable
Battery type| Li-ion 2200mAh 3.7V, Battery pack Voltage 3.7V| Battery cell in
appliance| 1
Operation
Working mode
High-low-SOS-flash-off Please pay attention for changing working mode: High
-Low-SOS: for this three mode changing,the interval between changing working
mode must be less than 10 seconds, otherwise, pressing the button will turn
off the lamp.
Battery power indicator
Four green lights on: 100% power; three green lights on:75% power; Ttwo green
lights on: 50% power; one recharge is required). During recharging, the
product could not be work. light on: 25% power(when this green light flashes,
Battery recharge
During recharging, the indicator will show as indicated following, step by
step: 1st green light flashes and turns on=>2nd green light flashes and turns
on => 3rd green
light flashes and turns on => 4th green light flashes and turn on=>fully
charged (all 4 lights turn on).
Other (Service, Repairing, Warranty, etc)
Have your product repaired by a qualified person. This electric product complies with the relevant safety requirements. Repairs should be carried out by qualified persons only using original spare parts; otherwise the user may be exposed to considerable risks.