LIVARNO home HG07911C Kids Paddling Pool Instruction Manual
- August 4, 2024
- LIVARNO home
Table of Contents
LIVARNO home HG07911C Kids Paddling Pool
List of pictograms used
| Safety information Instructions for use
---|---
| CE mark indicates conformity with relevant EU directives applicable for this
product.
Kids’ paddling pool
Introduction
We congratulate you on
the purchase of your new product. You have chosen a high quality product.
Familiarise yourself with the product before using it for the first time. In
addition, please carefully refer to the operating instructions and the safety
advice below. Only use the product as instructed and only for the indicated
field of application. Keep these instructions in a safe place. If you pass the
product on to anyone else, please ensure that you also pass on all the
documentation with it.
Intended use
This product is intended for use for playing/paddling. The product is suitable for children for 3 years or above. Any use other than previously mentioned or any product modification is prohibited and can lead to injuries and/or product damage. The manufacturer is not liable for any damages caused by any use other than for the intended purpose. The product is not intended for commercial use. The product is intended for outdoor use.
Description of parts
- Kids’ paddling pool
- Air valve
- Patches for repairs
Scope of delivery
Verify that the contents are complete and that the product is in perfect condition immediately after unpacking.
- 1 Kids’ paddling pool
- 2 Patches for repairs
- 1 Instructions for use
Technical data
Dimensions
(inflated) : HG07911B:
approx. 148 x 36cm (Ø x H)
HG07911C:
approx. 144 x 102 x 37cm
(L x W x H)
Safety advice
KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE!
Avoid the risk of injury!
RISK OF FATAL INJURY AND RISK OF ACCIDENTS FOR INFANTS AND
CHILDREN! Never leave children unsupervised with the packaging material
or the product.
The packaging material presents a suffocation hazard and there is a risk of
loss of life from strangulation and/or drowning. Children often underestimate
danger. Always keep the product out of reach of children.
- WARNING! Never leave your child unattended – drowning hazard.
- WARNING! Only for domestic use.
- Children can drown in very small amounts of water. Empty the pool when not in use.
- Do not install the product over concrete, asphalt or any other hard surface.
- Once inflated, make sure that the product does not come in contact with stones, gravel or other sharp objects which could puncture the item.
Non swimmers safety
- Designate a competent adult to supervise the product each time it is being used.
- Weak swimmers or non-swimmers should wear personal protection equipment when using the product.
- When the product is not in use, remove all toys or other objects from its surrounding that could be used by a child as a device to facilitate the access into the mini-pool (e.g. chairs, big toys, etc.).
Safety devices
- It is recommended to install a barrier (and secure all doors and windows, where applicable) to prevent unauthorized access to the product.
- Personal protective equipment, barriers, pool covers, pool alarms, or similar safety devices are helpful aids, but they are not substitutes for continuous and competent adult supervision.
Safety equipment
- Keep a working phone and a list of emergency phone numbers near the product.
Safe use of the product
- Encourage all users especially children to learn how to swim.
- Learn Basic Life Support (Cardiopulmonary Resuscitation – CPR) and refresh this knowledge regularly. This can make a life-saving difference in the event of an emergency.
- Instruct all product users, including children, what to do in case of an emergency.
- Never dive into shallow water. This can lead to serious injury or death.
- Do not use the product when using alcohol or medication that may impair your ability to safely use the product.
- When pool covers are used, remove them completely from the water surface before entering the product.
- Replace water regularly according to manufacturer recommendations and, depending on hygienic conditions, its cleanliness, its clarity, and its odour, or if any debris or stains are present in the product. Use of chemicals in products without water circulation may result in direct contact with the chemicals or in areas of high chemical concentration resulting in injury to the users.
- If chemicals are occasionally used to reduce the frequency of water replacement, follow chemicals manufacturer instructions closely (especially never use more than recommended), ensure the appropriate mixing of chemicals to avoid possible personal injuries and store chemicals out of reach of children.
- The use and installation of any electrical appliances around product shall be in accordance with the national regulations.
- Where applicable, remove any means of access from the product and store it out of reach of children whenever the product is not in use.
- Use of accessories not approved by the product manufacturer (e.g. ladders, covers, pumps, etc.) may result in risks of injuries or property damages.
Operation
Note: Before using the product for the first time, check it carefully for
holes, porous places and or seams that are not airtight by adult.
Recommendation: Blow up the product and leave it alone for one day. Air
new products in the open air for a few days.
Recommendation: Place the product on a level surface at least 2m from any
structure or obstruction such as a fence, garage, house, overhanging branches,
laundry lines or electrical wires.
Letting in air
CAUTION! Inflatable plastic products react sensitively to the cold and
hot. That is why you should never use the product when the ambient temperature
falls to below 15°C and rises above 40°C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible for pumping the pool
up. Make sure that you do not pump too much air into the product. On no
account should you use a compressor. Stop the process when resistance
increases during pumping and the seams start to stretch. Otherwise the
material might tear. Only use manual pumps and/or pumps specifically designed
for use with inflatable plastic products.
- Roll the product out first and then check for holes, tears and other damage.
- Open the air valve ( 2 ) and inflate the product.
- Close the air valve ( 2 ) and make sure it is sealed tightly. Press in the air valve ( 2 ) .
Deflating the product
- Pull out the air valve ( 2 ) .
- Deflate the product. Open the air valve ( 2 ) and pinch the valve shaft together slightly so that the air can escape or insert the deflation tube into the valve to allow the air to escape quickly
Cleaning and maintenance
- On no account should you use corrosive or scouring detergents.
- Use a slightly damp, lint-free cloth to clean the product.
- Change the water of paddling pools frequently (particularly in hot weather) or when noticeably contaminated.
Storage instruction
- Make sure that the product is completely dry both inside and out when wishing to store it for any length of time. Otherwise mildew and mould may form.
- Store the product in a dark, dry place–out of reach of children.
- The ideal storage temperature is 10–20°C.
- Ensure that the product does not come into contact with sharp objects during storage.
Repairing the product
Note: Minor damage can be repaired by the owner using the supplied repair patch ( 3 ) . Have any major damage carried out at a specialist repair shop.
-
First let all the air escape from of the product (see “Deflating the product”).
-
Cut the repair patch ( 3 ) to suit the size of the hole.
Note: Ensure that the repair patch ( 3 ) is larger than the hole and overlaps the edges of the hole. -
Round off the sides of the repair patch ( 3 ) and pull off the protective foil.
-
Place the repair patch ( 3 ) on the hole and press it down firmly. If necessary, stand a heavy object on the repair patch ( 3 ) .
-
Wait for 24 hours before you pump up the product again.
Disposal
The packaging is made entirely of recyclable materials, which you may dispose of at local recycling facilities.
Contact your local refuse disposal authority for more details of how to dispose of your worn-out product.
The product incl. accessories and packaging materials are recyclable and are subject to extended producer responsibility. Dispose them separately, following the illustrated Info-tri (sorting information), for better waste treatment. The Triman logo is valid in France only
Warranty
The product has been manufactured to strict quality guidelines and meticulously examined before delivery. In the event of material or manufacturing defects you have legal rights against the retailer of this product. Your legal rights are not limited in any way by our warranty detailed below.
The warranty for this product is 3 years from the date of purchase. The warranty period begins on the date of purchase. Keep the original sales receipt in a safe location as this document is required as proof of purchase.
Any damage or defects already present at the time of purchase must be reported without delay after unpacking the product.
Should the product show any fault in materials or manufacture within 3 years from the date of purchase, we will repair or replace it – at our choice – free of charge to you. The warranty period is not extended as a result of a claim being granted. This also applies to replaced and repaired parts.
This warranty becomes void if the product has been damaged, or used or maintained improperly.
The warranty covers material or manufacturing defects. This warranty does not cover product parts subject to normal wear and tear, thus considered consumables (e.g. batteries, rechargeable batteries, tubes, cartridges), nor damage to fragile parts, e.g. switches or glass parts.
Warranty claim procedure
To ensure quick processing of your case, please observe the following instructions:
Please have the till receipt and the item number (IAN 446453_2307) available as proof of purchase.
You will find the item number on the rating plate, an engraving on the front page of the instructions for use (bottom left), or as a sticker on the rear or bottom of the product.
If functional or other defects occur, please contact the service department listed either by telephone or by e-mail.
You can return a defective product to us free of charge to the service address that will be provided to you. Ensure that you enclose the proof of purchase (till receipt) and information about what the defect is and when it occurred.
Service
PDE ONLINE
www.lidl-service.com
Service Great Britain
Tel.: 08000569216
E-Mail: owim@lidl.co.uk
OWIM GmbH & Co. KG
Stiftsbergstraße 1
74167 Neckarsulm
GERMANY
Model no.: HG07911B/HG07911C
Version: 01/2024
Stand der Informationen · Last Information
Update · Version des informations · Stand
van de informatie · Stan informacji · Stav informací · Stav információ ·
Estado de las informaciones · Tilstand af information
Versione delle informazioni · Információk állása: 09/2023 · Ident.-No.:
HG07911B/C092023-8