KFi 106485 Rev B Polaris Ranger Highlifter Installation Guide
- August 2, 2024
- KFi
Table of Contents
KFi 106485 Rev B Polaris Ranger Highlifter
Product Information
Specifications
- Product: Polaris Ranger Highlifter Plow Mount
- Part Number: 106485 Rev B
- Kit Components:
- 1 Plow Mount
- 1 Hardware Kit HK-341
- 3 3/8-16 X 1.00 Hex Bolt Flange GR5 serrated
- 3 3/8-16 Hex nut Flange nylock GR5 (not all hardware is used)
Product Usage Instructions
Installation Instructions
- Remove bottom bumper Hardware (A) as shown in Figure 2 and set it aside for later.
- Place the mount over the bumper as shown in Figure 3. Reinstall bottom Hardware (A) through the plow mount into the same position they were removed from.
- Place Bolts (2.1) through the top of the mount and into the frame of the machine. Secure the Bolts with nuts (2.2) on the backside. Refer to Figures 1 and 3 for visual guidance.
FAQ
Q: What should I do if I am missing hardware from the package?
A: If you are missing any hardware needed to complete the mount, please
contact customer support for assistance in obtaining the necessary parts.
Q: Can I install this plow mount on a different vehicle model?
A: This plow mount is specifically designed for use with the Polaris
Ranger Highlifter. Installing it on a different vehicle model may not be
compatible or recommended.
Kit Components
| Item # | Qty. | Description |
|---|---|---|
| 1 | 1 | Plow Mount |
| 2 | 1 | Hardware Kit HK-341 |
| 2.1 | 3 | 3/8”-16 X 1.00” Hex Bolt Flange gR5 serrated |
| 2.2 | 3 | 3/8”-16 Hex nut Flange nylock gR5 |
- Not all hardware is used
- Note: Make sure all hardware needed to complete this mount is in the package.
- Thoroughly read through and understand the instructions before installing.
Installation Instructions
- Remove bottom bumper Hardware (A) as shown in Figure 2 and set it aside for later.
- Place mount over bumper as shown in Figure 3. Reinstall bottom Hardware (A), through the plow mount, and into the same position they were removed from.
- Place Bolts (2.1) through the top of the mount and into the frame of the machine, securing the Bolts with Nuts (2.2) on the backside. See Figures 1 and 3.
©2024 Copyright Kappers Fabricating, Inc. All rights reserved
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>