KFi PRODUCT 105375 Utility Vehicles Snow Plow Mount Installation Guide
- October 30, 2023
- KFi PRODUCT
Table of Contents
KFi PRODUCT 105375 Utility Vehicles Snow Plow Mount
Product Information
The Honda Big Red Plow Mount PART #105375 is a kit designed to mount a plow onto the front of a Honda Big Red machine. The kit includes all necessary hardware for installation, including a Plow Mount Bolt Plate, Hardware Kit HK-134, and various bolts, lock washers, and nuts. The kit is designed for extra strength and durability, ensuring that the plow can be securely mounted and used effectively for snow removal or other tasks.
Product Usage Instructions
Before installing the plow mount kit, make sure that all necessary hardware is included in the package. Thoroughly read through and understand the instructions before starting installation.
- Remove bolts (A) on the front lower panel of the Honda Big Red machine as shown in Figure 2.
- Place the plow mount over the front of the machine and install bolts (3.1) with lock washers (3.4) as shown in Figures 1 & 4.
- Place the bolt plate (2) under the front differential over the square cutouts shown in Figure 3. Secure the plow mount (1) to the bolt plate (2) using bolts (3.2) and lock washer (3.5). See Figures 1 & 4.
- For extra strength, drill holes and secure with bolts (3.3) and nuts (3.6) as shown in Figures 1 & 4.
- Tighten all hardware evenly.
- Refer to the UTV Plow Tube System instruction manual for tube attachment.
By following these instructions, the Honda Big Red Plow Mount PART #105375 can be successfully installed and used to mount a plow onto the front of a Honda Big Red machine, allowing for effective snow removal or other tasks.
Kit Components
Kit Components:
Item #| Qty.| description
1| 1| Plow Mount
2| 1| Bolt Plate
3| 1| Hardware Kit HK-134
3.1| 2| M10-1.25 X 30 Hex Bolt gR8.8
3.2| 2| 3/8”-16 X .88 Hex Bolt gR5
3.3| 2| 3/8”-16 X .75 Hex Bolt Flang gR5 Serrated
3.4| 2| M10 Lock Washer
3.5| 2| 3/8” Lock Washer
3.6| 2| 3/8”-16 Hex nut Flange nylock gR5
Note: Make sure all hardware needed to complete this mount is in the package. Thoroughly read through and understand the instructions before installing.
Installation Instructions
-
Remove bolts (A) on front lower panel as shown in Figure 2.
-
Place plow mount over front of the machine and install bolts (3.1) with lock washers (3.4) as shown in Figures 1 & 4.
-
Place bolt plate (2) under the front differential over the square cutouts shown in Figure 3. Secure plow mount (1) to bolt plate (2) using bolts (3.2) and lock washer (3.5). See Figures 1 & 4.
note: For extra strength you may want to drill holes and secure with bolts (3.3) and nuts (3.6) as shown in Figures 1 & 4. -
Tighten hardware evenly.
-
See UTV Plow Tube System instruction manual for tube attachment.
©2022 Copyright Kappers Fabricating, Inc. All rights reserved