Tekvox TSC7 Cable Housing Installation Guide
- July 31, 2024
- TEKVOX
Table of Contents
TSC7 Cable Housing
78036 Installation Guide
Included in this Product Package:
Step 1: Locate Position for TSC7
Position the cutout template on the table where the cable housing is to be
installed. Check carefully that the chosen position does not interfere or
overlap with any structural elements. See the following guidelines for
positioning the cable housing in different furniture types:
For tables with a single cable housing:
Position cutout template as centrally as possible. TSC7 should be within arm’s
reach from anywhere around table once installed.
For tables with multiple cable housings:
Position cutout templates centered relative to the table width, and at
consistent spacing from the table ends and one another (i.e. if using two
cable housings, they should be located 1/3 of the table’s length from either
end, ¼ for three housings, etc.).
For podia, desks, or daises:
Position cutout template in back corner of working surface to avoid
obstructing normal usage. Do not position template directly behind or in front
of mounting position of confidence monitor or touchscreen controller.
Step 2: Cut Hole for Mounting
Once cutout template has been positioned as desired, use a pencil to trace
around perimeter of template. Remove template. Carefully cut along traced line
and remove interior scrap portion. Clean up all dust and residue.
Step 3: Insert TSC7
After cutting and cleaning hole, carefully lower TSC7 into the furniture with
the lid facing up. Ensure that the housing fits the hole, and the that the
bottom of the rim is flush against the table surface. Enlarge hole if needed
to achieve proper fit.
Step 4: Assemble & Install Retention Brackets
Assemble retention brackets as shown:
Feed threaded rod through bracket, with wing nut facing angled side
Thread foot onto blunt end of threaded rod, tighten until snug
On underside of table, insert retention brackets into highest available slot on either side of TSC7. Pull brackets down to ensure they seat properly. Tighten the wing nut on each bracket until it exerts very light pressure on underside of table. Check that the TSC7 is properly seated and straight relative to the table edge, then tighten both nuts until snug.
Step 5: Install Cabling & Cable Retention Plate
Once TSC7 is securely fastened, run all user cables through central hole from
underneath. The TSC7 supports up to 6 cables. Ensure each cable is separate
fromthe others, and runs through one of the 6 semicircular cutouts.
Once all cables are run, insert cable retention bracket so that it aligns with
the mounting holes on either end, and completes all six cable passthrough
holes. Attach with 1 of the provided screws at each end. Tighten screws until
snug.
Do not overtighten screws, as this can permanently damage the cable housing.
Step 6: Attach Cable Grommets
Nylon cable grommets fit around each cable, and protect it from damage due to
the hard metal edges of the cable retention plate
For each cable in the TSC7, attach one of the nylon cable grommets by gently
pulling the grommet open and fitting it around the cable. Once the grommet is
around the cable, press the grommet into the cable pass-through hole. Ensure
that the cable can move freely, and that the grommet remains in place when
moving the cable.
Step 7: Finish Installation
Once all user cables have been fitted with grommets, retract the cables fully
into the TSC7, and close the lid. Ensure that the cables are dressed neatly
along the underside of the furniture, and that they are not tangled, twisted,
or kinked.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>