MySound ARHTV1T Wireless TV Headset User Guide
- July 26, 2024
- MySound
Table of Contents
Wireless TV Headset
Quick Start Guide
Want an easier setup?
Scan here for quick step-by-step video instructions
https://rcahearingaids.qrplanet.com/9l36nw
What’s in the package?
Charge the headset
Plug one end of an included charging cable into the charging jack on the left side of the headset.
Plug the other end into a USB power source (like a computer) or USB power adapter (not included).
The indicator light on the front of the headset flashes while the headset is charging.
Connect to your TV
MySound supports three kinds of audio from your TV:
– optical
– coaxial
– line-in or AUX
Look at the back or side panel of your TV and see what kinds of audio output
options it offers.
Then connect one of your TV audio outputs to the corresponding input on the
back panel of the MySound transmitter.
Optical and line-in/aux cables are included in this package.
Place the transmitter
The transmitter can be placed near your TV or mounted to the back of it.
To mount the transmitter to the back of your TV: Find where you want to mount
the transmitter on your TV and make sure the spot is clean and dry. Peel the
cover from the transmitter’s bottom to expose the mounting adhesive. Press and
hold the transmitter to the back of your TV for 10 seconds. Then gently
release.
Plug in the transmitter
Plug one end of an included charging cable into the DC 5V jack on the back of
the transmitter. If your TV has a USB power outlet, plug the other end of the
charging cable into this outlet.
Otherwise, plug it into an AC outlet using a USB power adapter (not included).
Pair the headset and transmitter
-
The transmitter turns on automatically when you plug it in (if it doesn’t, press and hold the button to turn the transmitter on manually). The OPTICAL indicator light starts blinking on the transmitter’s front panel.
If you’re using the OPTICAL input, proceed to the next step.
If you’re using a different audio input, press the transmitter’s button to choose that input (COAXIAL or AUX).
If the transmitter’s indicator light isn’t blinking, press and hold the transmitter’s PAIR button to enter pairing mode. -
Put the headset on and rotate its volume knob to turn it on. The headset makes its startup sound followed by a beep. This means it’s in pairing mode with the transmitter. After a few moments, the audio from your TV will start playing through your headphones (make sure your TV is on and its volume is up).
Using MySound
To adjust headset volume:
Turn the volume knob.
To adjust headset tone:
Press the TONE button on the front of the headset.
There are three tone presets:
increased bass, increased treble, and flat. Try each preset until you find the
one that works best for you.
Troubleshooting
If you don’t hear audio from your MySound headset, try the following solutions:
- Make sure the headset is turned on (its blue indicator light should be illuminated). Then turn the headset volume up using the volume knob.
- If the headset won’t turn on, it might need to be recharged. Use a provided charging cable torecharge it.
- Make sure the TV isn’t muted and that it’s still connected to the transmitter.
For complete troubleshooting and support, visit acousticresearchsupport.com
For complete instructions, see the User Manual that comes in this package.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>