FORTRESS POWER 10kW Inverter Instruction Manual
- July 26, 2024
- FORTRESS Power
Table of Contents
FORTRESS POWER 10kW Inverter
Product Specifications
- LCD Update Method: USB
- Recommended Firmware Update: Yes
- Maximum USB Flash Disk Size: 16GB
- Accepted Sizes: 16GB, 8GB, 4GB, 2GB
- File System Format: FAT32
- Allocation Unit: 4096 Bytes
Product Usage Instructions
Updating LCD Firmware via USB
- USB Flash Disk Size Selection: Choose a USB flash disk not exceeding 16GB.
- Formatting USB Flash Disk: Plug the USB flash disk into your PC and format it with FAT32 file system and 4096 Bytes allocation unit.
- File Path Configuration: Extract the zip file, copy the extracted folder named DWIN_SET to the USB Flash Disk.
FAQ
-
Q: Can I use a USB flash disk larger than 16GB for the firmware update?
A: No, it is recommended to use a USB flash disk with a maximum size of 16GB for the update. -
Q: What should I do if I encounter issues during the firmware update process?
A: If you face any difficulties or errors during the update, please contact our Technical Support for assistance using the provided contact information.
LCD update via USB
We strongly recommend updating the LCD Firmware to take advantage of the new
functionalities of the Inverter.
You will only need a USB Flash disk and a laptop computer to add the files to
it. Once you add the files you can re-use the same USB Flash Drive for all
installations.
Follow these simple steps:
-
USB flash disk Size Selection
The Size of USB flash disk must be not more than 16GB. The Following are accepted: 16GB ,8GB, 4GB or 2GB. -
Formatting USB flash disk
Plug the USB flash disk to your PC and select “Format.” -
File system configuration should be “FAT32” Allocation unit should be “4096 Bytes.”
And press “Start” to format the USB flash disk. -
File Path
Extract the zip file, Copy the extracted folder into the USB Flash Disk. File name must be “DWIN_SET”, -
LCD Firmware Update
- Power off the inverter by turning off the PV disconnect and all breakers. Connect the USB Flash disk to the USB2 port of the interface board.
- After the USB flash disk has been well connected and you can power on the inverter, then you will see the screen display below, it will keep staying in the page for 4 minutes and then the screen will restart itself, and if the firmware update has been done successfully, you can see the normal home page.
- Unplug the USB flash disk (hot-plug feature is supported by USB2 port). You can check the LCD version code in the right bottom side of the LCD display. You can also see the LCD version or Firmware version of the inverter under the “Device info” page.
Contact Information
For Technical Support Please Contact us at Tech-Support Contact
Information
Useful Links
Phone:
Tech Support 877-497-6937
Tech Support (Spanish) 215-710-8960
Support Tickets: https://www.fortresspower.com/support/
Warranty Submittal: https://www.fortresspower.com/warranty/
Fortress Power LLC
Information subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>